SKALN Heat transfer oil with high effective

1.Concentrated liquor should be added into liquor While modulating metal working fluid, reserve operation is not allowed

2.Compounding metal working fluid with hardness in 80-150PPM clean water, will develop the best using effect.

3.Trying to Proportion daily bulking liquor should be based on evaporation capacity, daily comsumption and the fluid attempt to determine

4.Add cutting fluid into machine tool groove which is used to load cuiting fluid ,and add 20 times the amount of clean water to stir evenly, then can be put into use

5.During using , cutting fluid will become turbid as the constant pollution,promptly clean up overloaded metal filing deposition, discharge and renew it while cutting fluid turn to black or odorous. accouding to various quantity of cutting, cutting fluid need discharge around every one or two months, daily supply with original cutting fluid .

6.In case pollute new fluid, when you discharge and renew cutting fluid and notice that pollution of sink bottom is very serious, must clean up immediately.