Single Cable Flame Spread Tester EN50086

Introduction:
Single wire and cable vertical burning tester is themost widely used and low cost of cable fire performance test equipment; single wire or cable burning tester meet the national standard GB /T18380.11-2008 / IEC60332-1-1: 2004 requiremen. It is to test cable , flameretardant insulation layer under fire conditions applicable for testing wireand cable in overheating, overcurrent and other non-normal state. It can beused in vertical or fiber optic wire and cable flame spread test, while testunder fire conditions Dettol matter combustion conditions.

International standards:

IEC 60332-1-1,2,3
EN 50086-1-1994
GBT 18380.11,12-2008
Features:

1, the touch screen intelligent control system; English user interface;

2, the system automatic ignition, automatic timing, automatic datastorage;

3, the test section and the control section is conbined design in onebox for operation;

4, stainless steel test box, the internal cavity size: height 1200mm,width 300mm, depth of 450mm;

6, a pre-mixed burner, an inner diameter of ¢ 12 ± 0.5mm, length is 100mm. 1KW hybrid standard burner,which provides accurate test fire source;

7, the flame burning applied time and hold time can range from 0 to 99 minutes99 seconds range adjustment. Automatic control of the testing process.

8, import needle vavle precisely adjust the flame height, according tostandards, thef blue flame height is 50mm ~ 60mm, total height 170mm ~ 190mm

9, the gas flow rate is controlled by needle valve

10, equipped with a steeless flame height caliper.

Specifiction: