[Product Name]
General Name: Serum Separation Gum (Irradiation Resistant)
[Specification] 20KG/barrel, 25KG/barrel
[Product performance] The product is colourless transparent colloid with light odor and no impurities, is physiological inert, insoluble in water, with relative weight of 1.045-1.065g/cm3, viscosity of 10-300,000 cpa, volatile matter less than 1.5%, and has excellent thixotropy and isolation performance. Other properties are detailed in the product test report.
[Scope of application] This product is specially used to manufacture disposable vacuum blood vessel harvesting and injection blood vessel harvesting, as a necessary material for the preparation of high-quality serum and blood samples for preservation, transmission and transfer in clinical tests.
[Notes]
The company's separating glue is a patent product with unique ingredients. Please do not mix it with other suppliers'products, so as not to cause product defects and unnecessary losses to you.
The recommended temperature range for separating gel is - 20 ~90 C. With the change of ambient temperature, the viscosity of the product will change greatly. Low ambient temperature may cause difficulty in gluing. It is suggested that when the ambient temperature is below 15 C, the water bath can be heated to 60 - 70 C to reduce the viscosity and improve the gluing efficiency.
The phenomenon of "drawing" occurs during normal temperature gluing, which can increase the gluing temperature appropriately or break the filament by vibration.
After high vacuum treatment, there is almost no air inclusion in the colloid. It is not recommended to mix in the process of transferring and adding glue, because mixing easily leads to a large amount of air in the colloid.
After adding the product into the test tube, the gel plane flow distance is less than 5 mm after 20 days of inverted test at 60 C in vacuum. It can ensure that no more than 5 mm flow will occur during 20 days of continuous transportation at 60 C by containers, and it will not affect the normal use of blood vessels. Even so, we still recommend that during the long transport process, the blood vessels with separating gel should not be inverted.
It is recommended not to touch the separating glue directly by hand. When adhering to the skin, you can scrape off most of the colloids with clean iron sheets, wipe off most of the colloids with waste newspapers, then clean them with DMC, D4 and other organic solvents, or clean them with detergent powder mixed with sawdust and detergent, and then rinse them with water.
分離橡膠進料料斗的清潔:來自不同廠商的更換分離橡膠,或將進料斗未使用和暴露於空氣中很長時間,並把它放回使用前進行清潔。該清洗方法如下:首先,圍繞料斗中的表面上的膠體與不銹鋼鏟去除,然後將其與在DMC,D4等溶劑中浸漬一刷清洗,然後將其進行清洗浸漬布在溶劑中。進料管也應清潔,防止污染膠體。
[警告和預防]
1.禁止使用血清凝膠時,發現有雜質,異物,異味,顏色異常和到期日。
2.本產品是惰性的,安全的和無毒的。
3.本品不宜與其他廠家的產品進行混合。混合可導致膠體分層,混濁等現象的出現。
4.超過建議儲存溫度極限可能損害分離膠的質量。
[特殊的儲存條件和方法除非在包裝標籤上另有規定,通常建議以保持在0-40℃的儲存溫度下密封(32-104華氏度)以避免直接暴露於空氣和陽光。
[有效期]36個月
德勝是一位資深的血液檢測試劑公司具有14年的研發和生產經驗。德勝對採血添加劑進行了深入研究。如果你需要異魯米諾,您可以聯繫18062302654(味辛是相同數量)。我們期待著您的來電諮詢。