1, usually goods by pallet, storage cage and other units set the warehouse shelves manufacturers keep the equipment ready. Within each unit load is in commonly 4000 kg, usually put two units on
each floor.
Heavy warehouse shelves manufacturers
2, is one of the most common and widespread use of warehouse shelves manufacturers, suitable for the vast majority of warehouse goods or products.
3, with 100% of the goods any chosen properties. Handling machinery such as forklifts can reach any goods store operations, store operation is convenient and fast!
4, with mechanical handling equipment storage operations.
5, unit warehouse shelves manufacturers generally within 4 m, span within 1.5 m in depth, low, high warehouse warehouse shelves manufacturer highly generally within 12 m, ultra-high, highly
warehouse warehouse shelves manufacturers generally within 30 m (such basic are automated warehouse, warehouse warehouse shelves manufacturers always made up of segments within 12 m pillar).
6, can adjust freely with 75 mm integer times each layer upon layer.
Heavy (beam type) warehouse shelves manufacturers generally
Narrow aisle
rack made of cold-rolled deformed steel columns by 80 (90) the x60 (70) Ω steel surface into diamond hole, beam x50 x50 x50 from 80-100-120-140 x50-160 x50 holding welding beam connection
accessories, generally on a tray instead of layer board convenient forklift. Layer 1 ton payload to the design of the 5 tons, surface electrostatic spraying, stronger waterproof rust corrosion
resistant ability, high safety coefficient, plug type combination, don't need to use screws and welding, the assembly is very convenient and make full use of the space area, provide warehousing
capacity.
Now the mould frame in a cluttered
Warehouse storage racks market, there are a
lot of just enter the newcomer is not clear, but just to give you simple science, mould frame is divided into:
1 and half standard mould frame, standard full mould frame
2. The models with day, crown crown into triangle with i-steel crown
3. Heavy;
4. All the open;
5. The sliding plate;
6. ShouShi.
On many non-standard products, our store can be customized according to customer's requirements.
Standard draw-out type mold product features
1, each drawer board will support 800-5000 kg
2, triangle crown (driving) bearing 800-1000 kg, i-steel crown in 2000-3000 kg
3, the drawer board smoke can all take out, all suggested smoking ninety percent. Smoke only smoke a half, but general advice a third time.
4 additional insurance device, safe and reliable. Three layers of insurance device, a safety pin, a layer of anchors.
5, adopting the combination of bearing operation of portable sliding balance with independent mould device
6, save a space, covers an area of product is 1.8 square meters, can deposit a few sets of small and medium-sized mold
7, simple structure, parts assembled by a variety of combinations, easy disassembly, transport and assembly
