Combined coal briquette dryer FUYU manufacture

Combined coal briquette dryer

1. Product introduction：

Combined coal briquette dryer is facing the now ubiquitous briquette drying furnace large amount of investment, covers an area of large area, the failure rate high case, for industrial briquette drying characteristics, the use of low wind and gravity principle, the R & D design and industrial test, the product replacement upgrade, put into operation and the large scale of several stages, which lasted several years and get the success of the product. In the product, fully embodies the application of innovation, development efficiency, reduce costs, improve quality. Vertical dryer production safety and protect the environment, is the ideal equipment of briquette production line for drying.

2. Working principle：

After forming the "water polo" conveyed by belt conveyor to the top by the distributing device evenly distributed to the top section. The briquette in its orbit while slowly moving by gravity side heat exchange with the wind. Coal moisture evaporated by strong winds was taken away. The briquette evaporation process about two hours to fully dry. Economic characteristics: compared with the general purpose of the present, the amount of investment is reduced by 1/2, the area is 1/5-1/3, and the energy consumption and operation cost are greatly reduced. Use features: This product is a good match, easy to connect with other devices in the production line and realize automation. Convenient operation and maintenance. No mechanical moving parts of the drying furnace body, no need to maintain the daily. Continuous operation, high efficiency, large output. To a large chemical fertilizer plant use, dry coal rods, achieved good results: into the gas furnace coal rods, the water will be around 3% of the gas production is significantly improved; a large number of savings venues, expanding production.

3. Main application：

Powder coal after forming machine to suppress the formation, the water is usually in the 12-14%. After drying, the moisture content is reduced to 2-4%, which can meet the strength and storage requirements. On the basis of this, the water can be reduced to less than 1.5%, and can also be used to dry mass of coal, coal and so on.