coal-fired steam boiler

Water quality adaptability is strong

Because uses the assembly, half assembly leaving the plant, installs the cycle and the fabricating cost compares other types of furnace approximately to reduce 1/3;

The setup time to be short, the expense is low

Because the chamber volume is big, has established the new chimney arch, moreover behind the firebox establishes the dust emission standard;

The boiler primitive platoon dust density is low

Because the massive highly effective heat transfer thread flue header puts in the pot shell medium, moreover approximately reasons and so on half pot shell outside surface heating, cause the boiler elevation of temperature time is obviously faster than other type of furnace boiler;

The boiler elevates temperature quickly

Because the Hot Water uses the mixed cycle, moreover the boiler water capacity is big, when cuts power suddenly, does not need to use the protective measures then to be possible to prevent the damage accident Which specially in the heating surface and the pot shell the medium possibly vaporizes causes;

The sudden power cut does not need to protect specially

Because uses the highly effective thread flue header, the water leakage temperature is smaller than was equal to that 130 degree Celsius hot water boilers and the capacity small steam boiler may cancel the rear part heating surface, moreover boiler highly in co-content type of furnace obvious somewhat low, therefore the boiler external dimensions are smallest, cause the boiler room the investment to reduce at least 1/3;

The external dimensions are small; the boiler room investment expenses are low

Because uses the highly effective heat transfer the thread flue header, and light of institute using the Harbin Engineering University the heat transfer, the resistance to flow technology carries on the design, this boilers actual output surpasses the data plate to strive generally 10-15%; Because the thread flue header geometry size and the smoke fast choice are reasonable, the boiler carries on normally when the thread flue header does not accumulate the ash, not to wear, thus the boiler output and the thermal efficiency do not lengthen along with the running time drop;

The output power is enough and continues for invariable

Features and specifications:

The main result of convection heating surface pipe thread set up in the pot shell, will then not leak into the cold air to the haze side, moreover, will cancel the rear part heating surface also to cause the boiler to leak into the cold air quantity to reduce and to reduce the radiation loss, next, because the Hot Water used the mixed cycle to cancel the province coal gas, then boiler noumenons water resistance lost does not surpass 0.05MPa, caused the systemic circulation energy consumption is the drop greatly, its drop value was bigger than the thread flue header haze resistance loss obviously the increase in value, then the boiler net efficiency was highest in each kind of type of furnace.

A coal-fired steam boiler or steam generator is a device used to create steam by applying heat energy to water.