12v Gear Motor PWM Variable Speed 12vdc

Manufacturer:  Wondermotor (wondermotor.com)


This is a brand new electric gear motor that has an extremely high torque and is speed adjustable with
a PWM (Pulse Width Modulating) controller.  The gear motor is measured to be 7 inch long and the
motor itself has a diameter of 2.5 inches.  Drive shaft is 10mm in diameter with 2 flats where flat to flat is
6mm.  The shaft has a threaded end that is to fit a M6 tightening nut.  Rated voltage of this gear motor is
13.5 VDC and maximum speed is 50 RPM.  Rated output load is 60 watts and output toruqe at 50 RPM
is 11.5 N-m (8.5 ft-lb).  Mounting is based on M6 screw mounting.  The 12V DC PWM controller features
a 4 ft(1.2m) long connection to its potentiometer.  The potentiometer has a on/off switch built-in with a
knob.  An overload protection is set at 6 amps of current so the controller will shut down when such a
current occurs.   There are connectors between the gear motor and the controller.  To run the gear motor
in CW rotation, please connect motor's green connector to controller's red connector and motor's red
connector to controller's black connector.  To run the gear motor in CCW rotation, please connect
motor's green connector to controller's black connector and motor's red connector to controller's red
connector.  The distance of the connection wires between the motor and the controller is 1 ft(30cm).  The
distance of the 12v connection wire is 10 in(25cm) long. 

12v Gear Motor PWM Variable Speed 12vdc

  • Country:United States
  • telephone:1-6263229220
This is a brand new electric gear motor that has an extremely high torque and is speed adjustable with
a PWM
*Your name:
*Your Email:
*To:WONDERMOTOR
*Subject:
*Message:
Enter between 20 to 3,000 characters. English only.     Characters Remaining: 0 / 3000
*Enter the secure code shown below Mfrbee security Image      Reload Image

We do inquire for you , please wait ...

Geared motors with variable speed pulleys

? Temperature sensor KTY or PTC. ? Protection cover. ? Reinforced shaft bearing. ? Condensation drain holes. ? 2nd motor shaft end. ? Feedback systems: resolvers, incremental encoders. ? Hand wheel. ? Increased centrifugal mass. ? Pluggable connectors. ? Variants for thermal ...

Come From Wadi Co.

Tung Lee-Linear Type Gear Head And Variable Speed Motor

Brand Name: tung lee(Gear Head And Variable Spe... Place of Origin:China (Mainland) Gear Head And Variable Speed Motor 1)smaller dimension 2)light weight 3)lowest noise 4)high quality materials ...

Come From Dong Xiang Fuyang Electrical Co., Ltd.