Flange,Welding-Neck,Slip-On,Blind,Threaded,Lap-Joint

Company Name:Hebei liqun Pipeline Trading Co.,Ltd

Bonnie

Best regards,

Waiting for your response at your convenience.

If you are interested in our products, please feel free t contact me. Your enquiry are highly appreciated, I will give you a quotation upon receiving your detailed requirements.

The socket welding flange is similar to a slip-on flange except it has a bore and a counter bore dimension. The counter bore is slightly larger than the O.D. of the matching pipe, allowing the pipe to be inserted into the flange similar to a slip-on flange. The diameter of the smaller bore is the same as the I.D. of the matching pipe. A restriction is built into the bottom of the bore which sets as a shoulder or the pipe to rest on. This eliminates any restriction in when using a socket welding flange.

Socket Welding Flanges:

The blind flange is a flange without a bore. It is used to close off the ends of a piping system and/or a pressure vessel opening. It also permits easy access to the interior of a line or vessel once it has been sealed and must be reopened.

Blind Flanges:

The lap joint flange is practically identical to a slip-on flange except it has a radius at the intersection of the bore and flange race. This radius is necessary to have the flange accommodate a lap joint stub end. Normally, a lap joint flange and a lap joint stub end are mated together in an assembly system.

Lap joint Flanges:

The slip-on flange has a low hub because the pipe slips into the flange prior to welding,It is welded both inside and out to provide sufficient strength and prevent leakage.Slip-on flanges are all bored slightly larger that the O.D. of the matching pipe.They are preferred over welding neck flanges by many users due to their lower initial cost, but final installation cost is probably not much less than that of the welding neck flange because of the additional welding involved.

Slip-On Flanges:

The threaded flange is similar to the slip-on flange, but bore is threaded. Its chief merit is that it can be assembled without welding, explaining its use in low pressure services at ordinary atmospheric temperatures and in highly explosive areas where welding create a hazard.

Threaded(Screwed)Flanges:

The welding neck flange is normally referred to as the high hub flange. it is designed to transfer stresses to the pipe, thereby reducing high stress concentrations at the bases of the Flange. he welding neck flange is the best designed butt-welded flange of those currently available because of its inherent structural value. t is expensive because of the design.

Welding neck flanges

Special design available according to requirement.

7.Place of origin: Hebei China

6.Package: seaworthy exporting package

5. Other types: WN,BL,PL,SE,SO,RF

4. Standard: ASME,DIN,JIS

3. Material: carbon steel, stainless steel, low temperature material

2.Specification: 2"-24"  Pressure:150LB-2500LB

1.Name: ,Welding-Neck,Slip-On,Blind,Thresded,Lap-Joint

Flange,Welding-Neck,Slip-On,Blind,Threaded,Lap-Joint

Name: Flange,Welding-Neck,Slip-On,Blind,Thresded,Lap-Joint
Size: 2"-24"
Pressure:150LB-2500LB
Standard: ASME,DIN,JIS