Link-Seal

Absorbs Shocks, Sound and Vibration-
This inherent benefit of Link-Seal helps reduce pipe failures due to fa

Compensates for Misalignment- Link-Seal allows for some angular and off-center pipe conditions and still seals effectively.

Corrosion Protection- Where insulation against galvanic corrosion (or electrolysis) is required, Link-Seal provides complete separation of pipe and casing. Metal-to-metal contact is eliminated.

Resistance to High and Low Temperatures- Link-Seal is available in special compounds that resist temperatures from as low as -60oF to as high as 400oF.

Fire Protection- For fire protection in floor and wall penetrations Link-Seal is Factory Mutual approved.

Seals any Pipe- If it's round, Link-Seal can seal it! Applications include concrete, cast iron, steel, copper, plastic, electrical and telecommunications cable.

Long Seal Life- Link-Seal is designed for use as a permanent seal. Many installations have been in service for 25 years. Seal elements are specially compounded to resist aging, ozone, sunlight, water and a wide range of chemicals.

Positive Hydrostatic Sealing-Properly installed, Link-Seal is rated at 20 psig (40 feet of head), which exceeds the performance requirements of most applications.

Link-Seal saves time and money- Link-Seal installs in up to 75% less time compared to lead-oakum joints, hand-fitted flashings, mastics, or casing boots. That means important cost savings

FEATURE

Model T: Silicone rubber is ideal for temperature extremes. "T" model is one hour Factory Mutual approved for fire protection in floor and wall penetrations.

Model O: Nitrile rubber is resistant to oils, fule and many solvents (gasoline, motor oil, kerosene, methane, jet fuel, hydraulic fluid, water...etc.)

Model C: suitable for use in water, direct ground burial and atmospheric condition. Provides electrical isolation where cathodic protection is required.

APPLICATION

Link-seal is designed to prevent the intrusion of moisture and other liquids in casing area. In addition, the seals can electrically isolate and support the carrier pipe. The seals are made molded synthetic rubber and connected  together by corrosion resistant bolts and nuts. The seals are resistant against aging, ozone and sunlight, and also available for environment with acids, alkalis, organic chemicals and extreme temperatures (- 67 degree F to + 450 degree F)

INTRODUCTION

Link-seal is designed to prevent the intrusion of moisture and other liquids in casing area