KBA-1510FP ADEKA ULTRA SEAL

GENERAL USE:
The product is designed for non-moving joints.
Because of its low expansion pressure, it can be
used in areas with a minimum of one inch of good
quality concrete coverage.
Lower expansion pressure allows the product to be
used between the wet face of the concrete and the
rebar provided there is a minimum of one inch of
concrete coverage. Placing KBA-1510FP in this
position will protect the rebar from moisture.
KBA-1510FP is suitable for use between non-moving
pre-cast segments where tolerances are within the
limits of KBA-1510FP (KBA-1510FP must be
compressed in all areas).
HYDROSTATIC HEAD:
Pressure Test:
1. Hold pressure for 3 minutes for every
0.05 MPa (7.1 psi) increase.
2. Increase pressure in 0.05MPa
increments until leak is detected.
3. Discontinue test for one week.
4. Resume test with above sequence -
increasing pressure by 0.10 MPa (14.2
psi)
Results:
NO LEAKAGE at 0.20 MPa (28.4 psi -

  • Country:United States
  • telephone:1-8009993959
GENERAL USE:
The product is designed for non-moving joints.
*Your name:
*Your Email:
*To:Adeka Ultra Seal / OCM, Inc.
*Subject:
*Message:
Enter between 20 to 3,000 characters. English only.     Characters Remaining: 0 / 3000
*Enter the secure code shown below Mfrbee security Image      Reload Image

We do inquire for you , please wait ...