Cleaning Cloths- No-Wet Micro Fibre and Terry cloths

1. Shake bottle vigorously for 10-20 seconds.
2. Pour into exclusive Micro-Mist applicator to fill line.
3. Pressurize bottle by "pumping" cap until resistance is felt.
4. Spray a light coat of NO-WET on the surface using a sweeping motion.
5. Wait 5-10 seconds as the NO-WET emulsifies and lifts the dirt from the surface.
6. Now use the first towel, gently rubbing in one direction to remove dirt and grime . As filmy haze appears, use the second cloth and buff to a clean and gleaming finish.
7. NOTE: To clear the spray nozzle, pump bottle, invert, and spray until you see a proper spray mist. (The same way you clean a can of spray paint)

When using to clean glass, wipe product off right away! When it comes to glass, LESS IS BEST!

Same instructions can be used for any other Non-Porous surface re:
Cycles, Boats, Window Glass, Shower Stalls, or what ever you can think of!
When Laundering your soiled towels, allow them to soak first, then launder as usual. DO NOT use fabric softener or dryer sheets, as these products will make the towels less absorbent.
Hand rub NO-WET into the surface using a circular pattern. This will ensure the most even application
A quick review of the directions:

Please use common sense; If dirty area is caked and packed,
knock off excess before micro-misting

Park your vehicle in a shaded area, and avoid applying NO-WET in direct sunlight. This will keep the product from drying too fast, and allow the surfactants to penetrate, lift and emulsify the dirt and grime on the paint surface

Use two clean 100% Cotton Terry Towels, one for cleaning and one for buffing. DO NOT use a cotton/poly blend, as synthetic fibers can potentially do damage (leave feather marks) to your vehicle's finish. Turn 32 oz. bottle upside down and shake for approximately 20-30 seconds before filling applicator. It is very important to make sure all ingredients are completely mixed.
To ensure a good spray, DO NOT fill the applicator bottle past the fill line. Using the pump cap, press up and down approximately 20 times until a resistance is felt, (cap will rise up about 1/2 inch). It is also important to continually pressurize the applicator during applications.
Mist over soiled area using a sweeping motion, keeping the applicator about 18-24 inches from surface, covering about 2-3 sq. ft. each time. Let set up for about 5-10 seconds, then wipe with first terry towel in ONE direction, (you are now picking up the dirt that is floating in the
NO-WET solution) first easy, then a little harder. As hazing appears, use second terry cloth and buff in circular motion to a clean and gleaming finish!

NO-WET is a Revolutionary state of the art concept in "waterless" wash, wax, polish & sealant. NO-WET contains 17 major active ingredients plus the finest , & Polishing Agents available!'.... NO-WET is the only product that can make that claim!

What Is NO-WET?