insert nut,embedded nut

Material can be comply with ROHS and WEEE directives.

Hole preparation
Moulded holes are recommended wherever possible. The taper on a moulded hole should be a inclusive and the hole diameter recommended should apply at the point reached when compared with a moulded hole. The top of the hole should not be chamfered or counter bored and care must be taken to avoid bell mouthing, hole diameter tolerance: -0.00+0.10mm
Wall Thickness
A general guide to minimum will thickness is given in the data table but this will vary depending upon the nature of the plastic. Where thinner walls are required these can often be accommodated.
Installation
The fastener may be installed using either a pre-heating process or using heat generated by ultrasonic vibrations. Where preheating is used, care must be exercised to ensure that the fastener softens but does not melt the plastic. This will avoid any tendency to generate unsightly flash around the top of the insert. Ultrasonic installation is best carried out using low amplitude vibration and the minimum power consistent with satisfactory softening of the plastic material. In either case excessive pressure should be avoided, since this may result in the insert being forced into the hole without allowing the plastic to soften and flow around the surface.

Application:PA,ABS,PP,POM,PC+ABS,PPO
Material:Brass
Embed Method: Heat or Ultrasonic

R type of Thread

Insert Nut,embedded nut

Insert Nut,embedded nut
Application:PA,ABS,PP,POM,PC+ABS,PPO
Material:Brass
Embed Method: Heat or Ultrasonic