HiBrite Lighting

Whenever you replace an aged bulb with a new one, your Enercon lighting investment will begin paying off all over again...causing a modest initial light output reduction, then quickly reaching a point where the lamp output is greater than it would have been without our treatment, so that the average light output over the service life of the bulbs will be greater with the Enercon controllers than without them.

Our Enercon lighting controllers instantly reduce the electricity usage of your lights by as much as 40%. And, this savings remains constant for the entire life of the bulbs, the life of the replacement bulbs, the life of the bulbs that replace those bulbs, and so forth, for decades into the future.

However, it may be only producing 50% of its initial light output.

Regardless of the age or light output of a fluorescent or HID lamp, the electricity consumed
remains constant. A two year old 250 watt light bulb will still consume 250 watts of electricity.

Thats not a bad return on your light investment.

Your initial willingness to invest 5%to 10% of your light output will quickly begin paying you
back with even brighter light than you would have had without the Enercon lighting controller
treatment, giving you as much as from one to three years of additional usable light output from the same bulbs.

The trend for light output reduction will be extended forward by this same amount of time, as
well. This means that you will have the light output you would normally lose at 10,000 hours still being produced at 14,000 to 18,000 hours. The lamps will lose output at a much slower rate than if they were not treated by our controllers.

With new or nearly new fixtures, using one of our lighting controllers set to a modest 30%
savings level, the life of the bulbs can be expected to be extended by 40% to 80%. This means that a bulb with a typical lamp life of 20,000 hours should last from 28,000 to 36,000 hours, when treated by one of our lighting controllers.

In effect, you are investing a little of your present light output in order to enjoy greater light
output, for a longer period of time in the future.

Yes, an Enercon lighting controller set to achieve 20% cost savings will initially dim your lights
about 2% to 5% from their previous output. However, over time, the average light output from your lights will actually be greater using our products than without them, from 10% to 30% greater, over the final 50% of the fixtures actual service life.

Your lights are dimmer today than they were yesterday. And, they will be dimmer tomorrow than they are today. In fact, as your lights approach the halfway point in their expected lamp life, they will only produce about 60% of the light they did when they were brand new.

Because the Enercon lighting controllers do not merely reduce voltage to a lighting circuit by
reducing the voltage waveform, but do so by a more technically sophisticated process of
waveform notching, the total voltage (RMS voltage) is reduced substantially more than peak voltage. This means that there is not a one-to-one relationship between energy cost savings and light output. In fact, depending upon the type, age and condition of the treated fixtures, light output will be reduced by only one fifth to one third of the level of savings achieved. Yes, these products do indeed dim your lights. Please read on before deciding this is a bad or undesirable effect.

Simply put, any electrical device drawing less current and at lowered voltage will produce less heat. Less heat in a lighting bulb, ballast or fixture translates into less degeneration of
components over time: again simply...longer life.

Enercon Internationals energy saving lighting controllers often inspire questions relating to
effects on lamp and fixture life, and about effects on light output.

Virtually no maintenance costs Pays for itself quickly

Reduces labor costs Color Rendering Index 85+ versus 65 for HIDs.

Increases productivity while creating a safer work environment.

36,000 to 38,000 hour lamp life Miro4 reflector, 95% reflective surface.

Less than a 7% light loss over the lifetime of the bulb versus 40%+ light loss in the first year with HIDs.

Instant on, no re-strike time versus 5-7 minute restrike for HIDs.

Increases usable light levels by at least 100%.

HiBrite Lighting products are leaders in the energy efficient, high bay lighting market, delivering superior usable light with no re-strike time and drastically reduced energy consumption.

HiBrite Lighting, a wholly owned subsidiary of Enercon International, Inc. is at the pioneering edge of energy conservation.