LED Lights

It can also be used in a boat or in a car or used as a yard light.

Our lamp can also be built into a street light with a small panel (10 watt panel for one lamp to run night over)

Where to use our LED lamp:  This lamp has been designed for use in solar energy systems, where low energy consumption is needed, and at same time get a very bright light. A small solar panel on typical 10 watt can run 4 lamps about 4-5 hours. This gives the possibility to make cheap solar systems for remote areas.

When taking of insulation and connect to external wire.

Installation: There are 2 holes in the side of the lamp where the wire from the lamp can be fit to installation wires. The 2 wires on the lamp are pulling protected thru a hole on the circuit board. But as the wire is thin be care full

Length of wire on lamp is about 10cm.

The black wire is negative. Positive wire can be red or white.

Polarity: Polarity must be correct. If wrong polarity, the lamp will not light.

Life time: expected life time 80.000 hour

Protection: The circuit board is coated with a varnish to protect against moisture. We recommend using the lamp indoor or mounting it so it not gets direct rain.    

Lamp housing: made in aluminum white painted.

Weight: 30 gram

Mechanical dimension:  75mm X 52mm X 13mm

Mounting: by screw to al kind of surface. (2 screw holes)

Light angel: wide spreading angle with no spot effect (120 degrees spreading angle).

12VDC Ultra bright LED lamps
Power consumption: 2W