3528 Waterproof SMD LED Strip

1.connector of strip to strip
2.onnector of strip to power

After cutting along the line, if you want to connect the cutting sections or connect
one section to power, the connectors will be necessary.

- Solder connection should only be performed on designated solder pads (marked +/-). During  soldering, don't exceed the maximum soldering time of 10 seconds and the maximum soldering temperature of 260 Celsius degrees.
- The smallest unit (3 LEDs) can be removed by cutting with scissors between the designated solder pads.
- The mounting of the strip is facilitated by means of the double-sided adhesive on the back-surface of the strip. Care must be taken to provide a clean and dry mounting surface, free of oils or silicone coatings as well as dirt partide. The mounting substrate must have sufficient structural integrity. Take care to completely remove the adhesive backing. Once the strip is appropriately positioned. Press on the strip with about 20N/cm2 (refer to application techniques of 3M adhesive transfer tapes).
- The minimum bending radius is 2 cm. The strip may be bent over a smaller radius of the circuit board containing no electronic components and such bends should be made once and fixed in position to avoid cyclic fatigue.

Application

LED Strip display Specification:

1, Waterproof LED Strip
2, lower power consumption
3, 3leds cuttable&easy installation
4, 5M/Roll
5, different colors

try led strip    smd led    to get through more products