Hard Stainless Steel Wire

Thewire shall withstand without breaking the minimum number of reversebends specified in table 3 for the appropriate diameter, tensile gradeand finish. The radius of curvature of the supports for the variouswire diameters is also given.

Thistest applies only to wire of nominal diameter between 0.5 mm inclusivead 3.7 mm inclusive. For wires of nominal diameter less than 0.5 mm.

Reverse bend strength

Note: Other tensile grades may be used on agreement between the manufacturer and the supplier.

Thesenominal values are the lower limits of strength. The upper limits areequal to the lower limits in addition to the tolerance specified intable 2.

The tensile grades of wires are:

Tensile grades

Thearithmetic difference between the two measurements of the diametershall be not more than half the tolerance specified in table 1.

Ovality of the wire

StainlessSteel wire for spring is made from the selected steel. In particular toprovide optimum spring efficiency, this type of wire is painstakinglyfinished to eliminate flaws.

Stainless Steel Wire for springs has following Characteristics:

KEl'sStainless Steel Wire for wire rope are manufactured having excellentmechanical properties, under strict guidance of technical people,diameter from 0.19 mm to 1.20 mm in bright finish and 0.50 mm to 6.00mm in matte finish (decoated) in grade of AIS1304, 316,321 rope specs.

ROPE WIRES

KEl's StainlessSteel Wire for Springs are manufactured having excellent mechanicalproperties (surface, cast & helix) manufactured under strictguidance of technical people, diameter from 0.19 mm to 1.20 mm inbright finish and 0.50 mm to 6.0 mm in matte finish (coated) in gradeof AISI 302, 304 & 316, 321, Standard ASTM A313 and others.

SPRING WIRES

KEl's Stainless Steel Wire for Springs are manufactured having excellent mechanical properties.