Dry & Wet Grinding Pulveriser

* All contacting parts Stainless Steel 304 / 316

* 220 Volts Single Phase motor insted of 440 Volts Single Phase Motor

* 110 Volts Single Phase motor insted of 215 Volts Single Phase Motor

Options of Dry & Wet Grding Pulveriser

Jas 1102

Dry & Wet Grding Pulveriser are exclusively meant for the grinding of chillies, Coriander, Dry ginger, Black Pepper, Turmeric and Curry powders, on a large scale basis. These spices are ground in a two / three stage operation, depending on the fineness desired, i.e. The breaking of the Turmeric in a large hole screen for the first operation, and the subsequent fine grinding done in a fine hole screen for the second and third operation. We give here below production figures for the same.

Application of Dry & Wet Grding Pulveriser

Open the cover of chamber all grinding parts cleaned with a brush in couple of minute and the Pulverizer is ready for next crushing. If required, the grinding chamber can also be wash with water. Remove the cotton balloon and the screen, close the cover tightly and start the grinder. Now pour a bucket or two of water into the hopper. The grinding parts will be flushed with the water and cleaned. Continue running the machine for a few more minutes as the draft of the fresh air sucked into the grinder will dry it. The beater when worm out removed and reserved by removing the cur clip lock holding to the rotor pins. When both the edges are worm out, they sharpened on an emery stone, to be use as new. In addition, when completely warn out, replaced the equal weight and refitted.

Servicing Guidelines of Dry & Wet Grding Pulveriser

The flow of material from the Feeding Hopper is regulating by means of side handle easily to suit the load. Rotor runs in anti-clockwise direction. The beaters pass just beneath the Ratchet Teeth Liner fitted inside the top half of the crushing chamber, leaving a gap of 1/8" between the liner teeth and the tips of the rotating beaters. This cuts the material caught between the liner teeth like a sword with a scissors action at a 2880 R.P.M. After the required size reduction, the material will pass through the screen fitted inside the lower discharge end of the grinding chamber. No sieving is required, as the appropriate size screen fitted will not allow coarser material to pass through. The air generated in the crushing chamber forces the powder to pass through the screen fitted at the bottom discharge end of the crushing chamber, into a Filter attached to the delivery trough below. (When crushing Wet-Pulpy materials, the balloon should not be use)

Operations of Dry & Wet Grinder: -

Jas wet & dry grinders

Dry & Wet Grinder Made from heavy duty Mild Steel fabricated body. Aluminum Grinding Chamber lined with serrated wear Steel plates, which protects the body from wear and tear. Grinding done by a set of Fixed beter on a balanced rotor. A screen classifier forms the lower half of the grinding chamber.

Construction of Dry & Wet Grinder

*One brush for cleaning of Dry & Wet Grinder

*One filter

* 3-meter cable with plug with miniature circuit breaker along with ampere meter will be fitted for overload protection for motor

*Set of 7 perforated round hole screens are supplied with Dry & Wet Grinder

The different standard accessories available with Dry & Wet Grinder : -

We have a wide range of Pulveriser that are designed and manufactured to yield maximum efficiency to our clients. These machines