- Height 1194 mm
- Width - 914 mm
- Length 1778 mm
- Dimensions: (Approximately)
water for protection
- Automatically shut down (Trip Off) in case of super pressure of oil or low pressure of
- Arbitrarily hands adjusting working pressure
- Special tool kit for maintenance / repair
- Working hour counter
- Inlet Water pressure for heat exchanger :0.8 mpa
- Voltage: 415 VAC, 50Hz, 3 Phase (Standard)
- Main motor power: 22 kw/ 30HP
- Inlet water pressure: 0. 4 mpa (For Intensifier)
- Max. Flow rate: 2.3 lpm
- Max. Output pressure: 55000 psi (380 mpa)
KMT Jetline JL-I 30
TECHNICAL SPECIFICATIONS:
- Environmentally friendly and clean production without poisonous gases.
- Tension-free processed parts due to minimal cutting force.
distances(partially free of burrs) and part-in-part production.
- Maximum degree of material utilization due to the smallest of part separation
single sheet.
- Material-saving production due to reduced cutting width and the nesting of several parts on a
- Flexible processing of virtually all materials with consistent high quality.
- Cold cutting without thermal influences.
ADVANTAGES OF WATER JET TECHNOLOGY:
Ceramics,Stones, Glass, Metal Artwork, Metal Cutting,Exotic & Non Traditional Materials, Automotive, Aerospace, Electronics, Job& Machine Shop Applications, etc.
This machine can be used for following Applications and Industries:
Water Jet Machine uses cold supersonic abrasive erosion to cut almost any materials both metals and nonmetals. The highly pressurized water stream is forced through a tiny area which carries abrasive garnet to erode away the material.
Acrylic,Alloys, Aluminum, Brass, Carpet, Ceramic,Composites, Copper, Corian, Felt,Foam, Fiberglass, Formica, Gaskets, Glass,Granite, Inconel, Insulation,Laminates, Leather, Marble, Plastics, Quartz,Rubber, Silicone, Stainless Steel,Steel, Stone, Titanium, Wood, etc.
WATER JET MACHINE CAN CUT RANGE OF MATERIALS:
A series of high-pressure lines, pumps and intensifiers force a stream of filtered water through a tiny orifice in a jewel. The stream, which is pressurized up to60,000 psi, mixes with fine abrasive garnet in a tube to provide extraordinary cutting power. Motion-controlled machines transport the jet nozzles along programmed paths to cut complex profiles.
PRINCIPLE OF WATER JET:
A Innovative CNC Water jet Cutting Machine can almost cut any materials as a good solution for complex cutting....
try water jet to get through more products
Model Number: | Jetline JL-I 30 Pump |
Brand Name: | A Innovative |
Place of Origin: | Gujarat India |
Precision:High Precision Controlling Mode:CNC Processing:Sawing Machine Brand Name:PTV Place of Origin:Czech Republic High-pressure water jet X-Y CNC table. ...
Come From EI-PRAGUE SRO
Precision:High Precision Controlling Mode:CNC Processing:Sawing Machine Brand Name:PTV Place of Origin:Czech Republic High-pressure water jet X-Y CNC table. ...
Come From EI-PRAGUE SRO