Positioning of side guides
|
Positioning of back stopper with pre-set.
|
Distance of front gates and the distance between upper & lower feeder rolls.
|
The front of Black is fed frictionally in vacuumed foundation and the Rear of Blank is fed by kick feeding in vacuumed condition. Vacuum is controlled in Center Part of Blank and
unnecessary friction is lessended in this part.
|
Bad feeding is detected by Parallel checker and Main Motor is automatically stopped.
|
Paper Waste-Power Removal Device is equipped with for accurate and uniform printing performance
|
|
|
Positioning of pull-collars. distance between upper & lower pull rolls, and distance between pining cylinder and press roll for board thickness are adjustable automatically by
pre-set.
|
Maximum 4 Printing Units are available and multicolor printing by using Mesh-Die is possible.
|
'O' point of printing by using mesh-Die is possible.
|
Flex C-3 Ink Saving Device makes ink changing quick, cuts down ink losses and saves cleaning water. (Option)
|
|
|
Four main shafts precisely ground with hard chrome plated for easy movement of creaser & slotting heads.
|
Creaser and trimming heads are provided on first two shafts and the other two shafts are provided with slotting and corner heads, which can be easily moved according to the box
size.
|
Dial gauge with gear system is provided on one side of slotting shaft to adjust the slot.
|
|
|
Our die cut system has an upper die drum & a lower urethane anvil drum. Polyurethane Belts are wound on steel drum. So, urethane cover is easily and partially replaceable and cost
is inexpensive.
|
Positioning of pull-collars and adjustment of distance between upper & lower pull rolls are automatically done by pre-set.
|
Urethane Anvil Cover Scraper and Circumferential Speed Synchronizing Device assure unsurpassed precision of die cut.
|
|