Thermal Dryers

High volume throughput Continuous 24 hour operation Mobile Process Low Emissions Cost Effective processing rate per tonne User friendly, does not require a process engineer to operate the system Containerised control room OperationThe System is essentially a rotary kiln with certain design features in the main rotary chamber and dust collection cyclones suited for drill cutting and other high dust laden materials.Contaminated material is loaded via a bucket type conveyor into the rotary chamber for thermal treatment.As the materials pass through the chamber it tumbles with the rotating action of the chamber, producing a mixing effect. The material is heated by a large fully automatic burner.Burners can be Dual fuel fired Oil and Nat gas or waste oil fired as required.As hydrocarbons/oils and other contaminants heat they reach a flash point and heat is then released, which is then used to preheat incoming material and the main burner modulates down to a fuel saving setting.The 'cleaned' treated material, solids then progresses into the drop out chamber, the hot gases and dust pass into a second phase combustion system where it is further treated and any pollutants are oxidised. Dust is collected in the two stage cyclone system. Further filtration can be added if standards require.Treated material then exit the system automatically via a conveyor system and deposited to a convenient location. OptionsFlue Gas Filtration System Emission Monitoring System Mobile Tractor Mounting