- All new design for CNC ready machine.functional,and innovation.
- Support MPG,axis direction,coolant,and spindle control in one touch pad.
- Integrate with Assembly bench desk,table cover,easy moving and install,machine cost affordable.
- X, Y, Z axis are all updated with ball screws, including two screw nuts, plane bearing and couplers. All these will provide very high localization accuracy. It has two 23 high speed stepper
motor for X, Y axis and a big moment 34 one for Z axis.
- The 34 stepper motor are smartly installed in the base of the machine, it has the direct link to the Z ball screw with a coupler. This installation has better accuracy than other conversion
plans. Whats more, it will not take extra room to influence the installation of the back shell.
- All the stepper mounts, ball screw mounts are made of steel, by wire cut machines. So they have good size precision and best rigidity than other plans which using aluminum materials.
- The X, Y axis steppers, we made shells to protect them from fritters. Of course, the Z axis stepper does not need a shell, it is completely hidden inside, and we cant see it after
installation at all.
- Photo couplers are installed in every axis as the limit/origin check switch. They have very good accuracy to set up a machine coordinate system just like real industrial machines.
- For the NC system power supply, we have two 300W switch powers to supply the three stepper motors. Two 23 motors of X, Y axis use one together and the 34 motor use one singly. So the power
system provides quite enough power to hard work.
- For the NC control system, including CNC interface board, three stepper drivers, provide quite all-around functions such as STEPPER FREE, EMERGENCY STOP, LIMIT/TOOL ADJUST SENSORS, SPINDLE
CONTROL, HALF DRIVE CURRENT, OVER-THERMAL PROTECTION, etc. About its performance, it provides subdivisions up to 100, the performance even near to a servo system. We recommend you use the system
with upper software such as MACH (we think the best), KCAM4.
- All the power supplies, NC control systems are all integrated to the back shell, so the total machine looks still very compact. You dont need to have a extra control box or power supply at
all, just turn on the power switch of the mill, all the NC function will start together. Joint the interface connector on the shell and your PC parallel interface with a cable we offered, you can
enjoy the CNC mill so easy!
- To strengthen the heat sink of the electronics in the back shell, we add a 12CM fan on the shell to cool them. So you dont need to wary about the stability when summer.
- All exposed wires are covered by plastic corrugated pipes to make the machine looks cool. A switch is set to the position where the Z axis hand wheel has been. You can use it as coolant
switch or FREE, or EMERGENCY STOP.
- At last, maybe you have seen on the first sight, we installed a 3D bracket with a tray on it. The bracket can be localized at any height, position it can reach, and the tray can be turned
360
SyiL CNC machine, No. 1 Brand in the world, affordable cost. Super Dealer Service And Support. SyiL. Com