MG-26 FRP rebar pultrusion line

20000*1850* 1450mm

Dimension

700mm

Cutting journey

Limiting switch

Length setting mode

(W*H) 600*65mm

Cutting range

2850rpm

Cutting speed

1200mm

Clamping length

500mm

Clamping width

0.1-1m/min

Traction speed

Max. 40Kn

Traction force

9-95rpm

Winding rotation speed

Max. 26mm

Winding diameter

2

Number of winding heads

1000mm

Center height

20Kw

General power

0.4-0.6Mpa

Air pressure

380V/50HZ

Working voltage

Technical parameter:

Dry oven: adopts cast aluminium heater, intelligent temperature controller to control the temperature. The heating box adopts mesh structure and it is easy to open it and clean the dropping resin, filled with insulation materials inside. 

Winding device: adopts gear wheel to drive the roller turn around the products, and wind the thread. This device adopts frequency conversion speed-regulated mode, adjust the rotate speed stepless.

Dipping glue slot: welded by stainless steel material, there is press roller inside to make the roving dip in the resin sufficiently.

Yarn support: used to place the yarn spool, adopts the welding structure of steel plate, steel pipe and angle iron.

This line mainly consists of yarn support, dipping glue slot, winding, dry oven, haul-off machine, cutting saw and tilt tipping device.

Equipment Characteristic:

This line is used to produce FRP rebar with different specification. It can finish distributing yarn, dipping glue, pre-molding, winding, heating and hardening, traction, set-length cutting and pile up automatically.

MG-26 FRP rebar pultrusion line

This line is used to produce FRP rebar with different specification.