track link recapped machine

 And then move up  the main operating handle of the main fuel tank.After  start the operation, when Another two feet  of  the ladder four tripods mold insert into the screw holes on the other 2 sides of the chain .In this process, the chain assemblage ends.In this way ,repeate operations introduced above  until the completion of assemblage.
4. When assemble the chain , the first section dose not overlap the shaft, while the final section must  oppress the short-chain sleeve.

4.      Put the chain to be assembled in front of the model which close to the baffle board side on the working platform .Before assemble  the  chain,  the screw hole on the chain should bewhen the chain  must be at the top. And 2 feet of  the trapezoidal four tripod ladder mold should be insert  into the 2 screw holes on one side of chain.

(II) .method to assemble the chain :
1. In order to make the  chain renovated  can fit  the chain  board successfully when assemble them together, making  a mold for measuring  horizontal pitch  is required before the chain assembly .The Specific production methods  is : Insert 4 small iron  poles ,which size is similar to the the inner diameter of the scre holes  in  the chain board, (which suit to the chain to be assembled). And then use  another four irons poles solder the former 4 small iron bars .In this way we get the mold which we called  the trapezoidal four tripods mold.
2. Disassemble the model for demolishing the chain and  the roof installation from the working platform ,and install a set of model for assemblage  on the push board and the baffle board .

4. Fix on  the socke board of the gate  ,and move the handle of the main fuel tanks upwardly .This process will extend the push  board to separate the chain apart, and then moved back to the operating handle of the main fuel tanks .Move the operation handle of the vice fuel tank upwardly.In this way ,the next section of the chain  will be drived on the working table  to be demolished successively. In this way, repeate the  operations introduced above  until  complete  the whole  demolition.

3. Turn on the motor control switch, moving upwardly the  operation handle to the  vice fuel tank, in order to make the fuel tank pole  extend to the  demolished  part of the chain. Pass through the chain and the hole in the head of the fuel tank pole with an iron bar from the downward .And then push down the vice operations handle  of  the fuel tank, fuel tank will retrieve to drive the chain go to the working  platform;

2. Put the chains to be disassembled  on the delivery chain  platform, the  screw hole of the chain need to be put in the bottom;

(I).method to disassemble the chain:
1.  Install the disassemble modle on the push board, the roof installation fix in the baffle board on the table;

IV.Specific methods of operation

(I). The mold carried by the machine  (a demolition mold, a  assemblage mold ) in order to facilitate users to learn about the characters and use of the machine , but they may not  necessarily be applying to  all  the chains or axle sleeves .
(II)When the equipment operating, operators must take the appropriate protective measures. Otherwise  accidents happen, Haoli enterprise is  not  responsible for the accidents.

III.Attention

1500mm

Roller chain renovating machine ---- -- model HLBG - 85T ,designed and manufactured by Haoli engineering machanic enterprise,is