saw board edgers Reckart R848TA

Available Options not Included in Base machine:
Overhead motor mount and guard for drive
Moveable saw assembly, less saw
Two saw assembly moving in unison, less saws
Stationary saw collar
Starting and finishing collar with bolt to be used with saw banks
Each additional saw spacer
Powered guide fence 0"-12" (must have power pack)
Powered crowding roll (must have power pack)
Hydraulic power system to operate guide fence or crowding roll
Air lift loading and crowding chains with reverse 2 chain unit or 3 chain unit
2 chain unit inside of infeed table, each chain to work independently with forward and reverse to center cant. Includes 20 HP power pack with starter wired into control panel Split pressure rolls with hydraulic control cylinder on both sides. Unit includes 5 HP power pack with control valves Split feed & infeed table rolls
200 HP motor and vee belt drive
Extra per foot to extend outfeed table behind edger
Extra for each additional roll for outfeed table behind edger (Std no. rolls (7) seven)
Extra for 5 HP two speed motor and drive for outfeed table
Extra per foot for extension of cover over transfer chain std. 20'

Reckart R848TA
 Standard unit to have 1-1/4" side plates, 48" width opening for maximum cut of 8-1/2" thick material. Unit with 4-1/2" chrome mandrel and 3-15/16" bearings, 6- 6-1/2" inserted tooth powered bottom feed rolls, 4- 6-1/2" inserted tooth pressure rolls driven with #100 RC. Unit has hydraulic cylinder from pressure rolls, which raises and lowers thru automatic switch with manual override, 5 HP hydraulic system wired for 3 phase, 460 volt with control panel, 10' infeed table with 4 - 6" X 48" X 1-15/16" rolls, 18' powered outfeed roll table 6" x 48" X 1-15/16" rolls. Unit has side and top guards with 20' clearing span guard over transfer chain with 1" plate for stops. No drive motor, starters or disconnects, saw spacers or saws.