saw board edgers Reckart R642 hd

Options:
Air lift safety fingers
Two saws moving independently in place of in unison
Tube type adjustable guide fence 0"-6"
Stationary guide fence
10' rear table with 3-6" rolls, 1-7/16" bearings
10' outfeed table with 3-6" live rolls driven from edger
5" X 20' belt tailer driven from edger
14" X 20' belt tailer driven from edger
42" X 20' belt tailer driven from edger
5 HP independent drive for belt tailer
21" carbide tipped saws, each
20" inserted tooth saws, each
Stationary saw collar, starting and finishing collar, bolts, one collar for two saws
Each additional center collar under 2-1/8"
Each additional center collar between 1-1/2"-4"
Hydraulic power shift, including hydraulic tank, pump, motor and control valve for two saws moving in unison
Cant holdover mounted in infeed table with air cylinder and control valve
Cant holdover powered from hydraulic power pack
Powered rear pressure rolls
Complete moveable saw collar
U joint for moveable saw
6" X 6" roll for cant holdover 1-15/16" bore
EXTRA for 48" wide machine in place of 42"
EXTRA for 48" wide machine with 3-7/16" mandrel and bearings and 1" side plates in place of standard
EXTRA for spray mist unit with manual valve for mandrel and 1-1/4" slide shaft
EXTRA for 7-1/2 HP motor and larger tank on hydraulic system, hydraulic motors installed on each 1-1/4" shaft that turns only when saws are being shifted
EXTRA for overhead motor mount and guard
DIMENSIONS (Edger Frame)
Base Length 64-1/2"
Base Width 72"
Infeed Table 10'0"
Outfeed Table 10'0"
GENERAL CONSTRUCTION
Side Plate "Frame" 5/8" Plate Steel
Arbor 2-15/16" T.G.P
Feed Rolls 6-1/2" Inserted Tooth
Press Rolls 8-1/2" diameter
Saw Collars Ball Bearing
PERFORMANCE
Max. Depth of Cut 6-1/2"
Max. Width of Material 42", less saw setting
Feed Rate (Edger side) 135 L.F.P.M
Feed Rate (Cant side) 55 L.F.P.M
Mandrel Speed 1770 RPM
Arbor Size 2-15/16"
Power Required: Main drive motor 30-200 HP (Not included) Feed roll drive motor 2-5 HP

Reckart R642 hd
Includes 10' infeed with 4 - 6' table rolls, with 1-7/16" shaft and bearings. The table is constructed of 6" channel frame with legs, with one adjustable tube type guide fence 0"-6". The main frame is made of 5/8" flat steel with 2-15/16" mandrel with outboard bearing on adjustable bearing base. Unit with (4) 6-1/2" inserted tooth feed rolls with 1-11/16" shaft and bearings that are driven by #80 roller chain with (2) 5 HP motors through speed reducers. Unit wired for three phase, 460 volt with reversing starter on slow side, controls for slow, fast, stop and reverse. Unit has (2) 8-1/2" diameter pressure rolls with air lift cylinder and down pressure. Unit has one stationary saw collar and two ball bearing saw collars with movable saws moving with hand wheel in unison, with anti-kickback fingers and guards for top of edger and overdrive unit, unit with bottom safety fingers. Unit LESS: Rear table, main motor and drive Unit accepts 21" saws.