Gas Leak alarm

 * After the wiring connections, in accordance with methods of operation, the various steps to confirm the action.

 * Control Division of the Ministry of connection with the cut off, +, - very connected to accurately (red + pole; black - pole).

 * The alarm signal lines on the link to the Control Division of the signal terminal.

 * Wires should be an adequate cushion to cut the Department of the Ministry to ensure the control, control the Ministry of alarm links.

 * Open the controller front panel, as shown connected to the terminal.

 * The Control Unit may be a gas leak alarm linkage of three loops.

 3. Control Division, cut off the department, alarm wiring methods.

    * To cut off the device into the valve on the main channel after the valve handle and cut off the central axis of the drive shaft into a vertical docking device, fixed to the valve into the gear box on the top, with a fixed cut off wrench device.

 2. Cutting Device Installation Method

  LNG, gas (light): more than a small proportion of air from the ceiling within 30CM to install.

  LPG, gas (weight): ratio of the large proportion of air from within the installation of ground-30CM.

  Alarm - Gas alarm installation position due to the different types of gas, its installation location is also different. Please confirm in advance the type of gas.

  cut the department - in charge of the Ministry of Road cut off valve is installed.

  Control Division - convenient location. Easy to operate hand position.

1. Select the installation location

-30 75

Continuous Service Temperature  

62W

Kwh

AC 220V/60Hz

V AC 

DC 36V

DC-V

200A, 250A, 300A

Specification

GSV-303-300A

Automatic alarm when a gas leak and cut off the gas valve