Battery Powered Smoke and Heat Alarms

ApplicationsParticularly useful for locations such as stairs and exits routes where the high intensity light beam will illuminate the escape route.Main FeaturesHigh intensity light beam powered by alkaline batteryHigh sensitivity responds to all standard firesDual ionisation chamber quick response to fast flaming firesBattery powered 9 volt (supplied)Built in sounder to give a minimum sound output of 85dB(A) at 3mBleeps every 40 seconds when battery needs replacingEasily installed no wiringTest Button simulates smoke use to check performance at least monthly5 year guarantee (limited)InstallationFor full Installation and Siting Instructions please refer to the Use and Care ManualThis Alarm is battery operated and needs no wiringPull cover open at Tab. Remove cover from base by separating at rear snap-in hingesPlace the base on ceiling or wall exactly where you want to mount the unit. With a pencil, mark the location of the screw holesTaking care to avoid any electrical wiring in the ceiling or wall, drill a hole through the centres of the marked locations. Push the plastic screw anchors provided into the drilled holes. Screw in firmlyWith a pencil, write the date of battery installation on the inside of the cover to remind you when to replace the battery. Lift battery from battery holder, and snap battery connectors to battery. They fit together only one way. Gently push battery into battery holder. To close the cover match up snap-in hinges and gently press together until base and cover snap togetherAll models are fitted with a warning flag which pops up when the battery is removed. This prevents the cover from closing when there is no battery in the unit. When the battery is being installed or changed, this flag must be held down while gently pushing the battery into the battery holderTrouble ShootingNuisance/False Alarms occur:If, when the alarm goes off, there is no sign of smoke, heat or noise to indicate that th