Wood Moisture Tester

2. Inside the mailed packing carton, it should be filled with shockproof material. On the outer packing, it should be marked with downwards ,handle with care, caution against wet. The packing should fit inland waterway transportation.

1. It should be stored in the clean and dry place, at RH<85%, temperature 0~40. If long time no use, take off the battery.

Storage and Shipment

(4) Change batteryIf the above test cannot be fulfilled or the luminous tube lights up dimly, it means the batterys volt is under 10V and should be replaced by a new one.

(3) When pressing Range button or , if two adjacent luminous tubes all light up, then take the average of the two readings. You can also increase and decrease the reading in proportion according to varied brightness.

(2) When pressing Range button, if no luminous tube lights up, it means the reading is under 16%,you should change to Rangeand to read out again. If only the downmost tube lights up, it means the reading is above or equal 35%.

(1) When pressing Range button, if no luminous tube lights up, it means the reading is under 7%; if only the downmost tube lights up, it means the reading is above or equal 15%. You should change to Range , and to read out again.

On measuring, take note of the readings in the following several cases.

Attention!

Twist off the screw on the back  Inspect inner constructure  Replace the battery

How to replace battery?

3Measurement: Insert the four steel needles into the wood material in 6mm depth, press the Range button and read out the data beside the corresponding luminous position. If Range buttonis pressed, read the left row; If Range button is pressed, read the right row.

2Inspection: Short-circuit the left and right steel needle by connecting it with hand or metal. When pressing Range button, the downmost luminous tube should light up, and the other tubes should not. Open-circuit the left and right steel needle (with no electric conductor connected). When pressing on the Range, all luminous tubes should not light up. Meeting all before-mentioned, it means it works well.

1Battery: Put a 15V battery into the cell box, with anode upwards.

Use method

* Weight180g                                                                    

*Size:185