BM150 Power Clamp Clamp-on Multimeter
Product Details
Measurement Category IV (CAT IV)
is for measurements performed at the source of the low-voltage installation. Examples are electricity meters and measurements on primary overcurrent protection devices and ripple control units.
Measurement Category III (CAT III)
is for measurements performed in the building installation. Examples are measurements on distribution boards, circuit- breakers, wiring, including cables, bus-bars, junction boxes, switches, socket-outlets in the fixed installation, and equipment for industrial use and some other equipment, for example, stationary motors with permanent connection to the fixed installation.
Measurement Category II (CAT II)
is for measurements performed on circuits directly connected to the low voltage installation. Examples are measurements on household appliances, portable tools and similar equipment.
Measurement category I (CAT I)
is for measurements performed on circuits not directly connected to MAINS. Examples are measurements on circuits not derived from MAINS, and specially protected (internal) MAINS derived circuits.
the BM150
PowerClamp Clamp-on Multimeter Series
- Country:Taiwan
- telephone:886-886 2 2226 3396
|
the BM150 PowerClamp Clamp-on Multimeter Series |
Send inquiry / quota request to BM150 Power Clamp Clamp-on Multimeter
Relate products of BM150 Power Clamp Clamp-on Multimeter
This GF6018A high precision multi-product calibrator is compliance with national verification regulation: JJG124-2005 \"Ammeter, voltmeter, power meter and resistance meter verification rules\" and related national standards. 0.05% single-phase standard AC/DC voltage and ...
Come From gfuvegroup
1.KV-A large vertical lathe chuck has 15 inch, 18 inch, 21 inch,24 inch,28 inch,32 inch size specifications to choose . 2.For the processing large diameter workpiece. 3.Gripping range:15 inch for 72-381 mm,18 inch for 133-450 mm, 21 inch for 62-530 mm, 24 inch for 152-610 mm, ...
Come From Zhejiang KEBO Machinery Co., Ltd
1.Diaphragm chuck is a fully sealed chuck, 3-jaw type, 6-jaw type to choose. 2.It is based on the outer diameter of the gear P.C.D for clamping, can process the gear diameter and the end face so as to achieve better concentricity requirements. 3.Processing different size of the ...
Come From Zhejiang KEBO Machinery Co., Ltd
