liquid Injection Molding Silicone Rubber for gasket, o ring

Its the non-dangerous goods, and it should be transported as the common  chemicals.

Keep in dry place, the shelf time is nine months(Below 25)

7.Storage and Transportation:

Specification:40kg/set(A20 kgB20 kg); 400kg/setA200 kgB200 kg

6.Package:

 

5This product should be avoided being mixed with another kind of organic tin catalyst such as amines, sulfur, phosphorus compounds and some metal salts.Otherwise,the catalyst of this product will be useless that the mixed material will not be cured.

4Its non-dangerous goods.But pls dont have it  touch mouth or eyes .If it happens,pls flushing yourself quickiy with enough rinsing.

3It has the  connection for curing time to temperature of the material, the lower for the temperature,the longer for its curing time.

2The mixed material should be in sealed storage and be used up during the safety operation,or itll  slowly cure to wastage

1 Mixing  A&B compenent equably before using.

5.Precautions:

Injection molding:Put the mixed material which has been defoamed into the mold.The injection molding should be made under appropriate pressure,temperature , cycle and other conditions.

pumped when there is no bubble. Deaeration time is suggested to be 5 to 10 minutes or so.If there is no deaeration device,the next step can be proceeded when there is no foam in the mixed material,usually one hour after mixing.

Whipping: Adding B to vessel with A then mixing equably.
Defoaming:: Put the mixture in the vacuum deaeration device.Usually,it should not be               

Measurement: Be exact Metage for A and B components.

4.Usage:

2.0

2.0

2.0

2.0

2.0

%

Linear Shrinkage

13

12

11

10

8

%

Tensile set

30 

30 

35 

35 

15

N/mm

Tear Strength

300

400

550

500

400

%

Elongation At Break

7.0

8.0

8.0

7.5

6

Mpa

Tensile Strength

70

60

50

40

30

ShoreA

Hardness

1.14

1.13

1.10

1.08

1.07

g/cm3

Gravity

700

500

300

70

50

Pa.S

Voiscosity

Semi-transparent

Semi-transparent

Semi-transparent

Semi-transparent

Semi-transparent

 

Exterior

Item

ADL3106-70

ADL3106-60

ADL3106-50

ADL3106-40

ADL3106-30

Unit

Property Model No. 3.Technical parameters: ADL3106 serious has excellent elasticity and properties of anti-aging and resistence to high temperature afer curing under certain temperature(the temperature can be adjusted according to different demand).It has low linear shrinkage,resistence to impact fatigue,good thermal stability and cold resistence(the operating temperature is 60250).Below 20 ,the safe operating time in a sealed state after component A and B being mixed is 2 days.When the temperature becomes higher,the operating time will be shortened. 2.Features: This product is high tensile injection mold RTV2 liquid silicone rubber.It is suitable for cook,orings, rubber covered roller,keypad, rubber wares and other silicone rubber products. 1.Application: Model No.:ADL3106serious ADL 3106 Injection Molding Silicone Rubber

liquid Injection Molding Silicone Rubber
high tensile
for gasket, cook,orings, rubber covered roller,keypad, rubber wares,etc