OBD-II Scantools ELM 327 USB

The ELM 327 is a multi protocol OBDII Interface, which allows you to talk to your OBDII equipped vehicle using a USB connection for direct input into your PC or Laptop. The ELM 327 interface supports the following Protocols : * J1850 PWM (Generally ford vehicles manufactured between 1996-2005) * J1850 VPW (GM & some chrysler vehicles) * ISO9141-2 (TATA, Fiat, Honda, Hyundai, Skoda & Most imports) * KWP2000 (Chevrolet and some imports) * ISO15765-4 (CAN) (most 2005 & newer vehicles)Coupled with relevant OBD-II software the ELM 327 interface offers the following features: * Read, Display and Clear Engine fault codes (Diagnostic Trouble Codes) - both stored codes and pending codes * Switch off Check Engine light (MIL) * Full database built-in of generic fault code definitions * View live engine sensors such as Engine RPM, Calculated Load Value, Coolant Temperature, Fuel System Status, Vehicle Speed, Short Term Fuel Trim, Long Term Fuel Trim, Intake Manifold Pressure, Timing Advance, Intake Air Temperature, Air Flow Rate, Absolute Throttle Position, Oxygen sensor voltages/associated short term fuel trims, Fuel System status, Fuel Pressure an lots more * View the status of all 11 Inspection/Maintenance Monitors (on-board tests, e.g. Oxygen Sensor tests)The robust aluminium casing makes this Scantool most suited for users who work with various vehicles with different OBD-II Protocol.Features : * Robust casing for rough service use * Connects to PC/Laptop via USB interface ( uses virtual serial port ) * ELM327 compaitable Interpreter MCU for ISO9141, KWP2000, J1850 VPW, J1850 PWM & ISO15765-4 (CAN) protocols. * 5 LED indicator provides status on the state of the scantool while communicating with the vehicle o Power LED o OBD Transmit Data (Tx) o OBD Receive Data (Rx) o USB Transmit Data (Tx) o USB Receive Data (Rx) * Powered from car battery over OBD2 connector * Compatible with a wide range of available OBD2 software * Rugged Build and Compact Size : 70 x 80 x 25 mm ( L x W x H)