Warning Light

User Manual
Automobile Shark Fin alarm light is also called automobile top-vane. Its design is a simulation of
dorsal fin of the fishes, including sharp. The dorsal fin can effectively decrease the resistance of water; at
the meantime, it can adjust swimming gesture, so can be faster to run away or prey on. This product is just
similar to the fishes dorsal fin, by installing it on the top of automobiles, the wind-resistance coefficient
can be decreased; the automobile can also be stabilized by its downward pressure even in high-speed
driving. Shark Fin alarm light is just a product which is based on the above reflection. Besides, it adds one
function of LED-light blinking.
In the evening, the automobiles taillights are generally continuous red. The over-tired or long
time-driving drivers already get a kind of customary torpidity to this color; this torpidity easily cause
traffic accidents. Compared to this, people are sensitive to the flashing lighting, therefore the function of
 LED-light blinking is added. Rear-end collisions due to the weak vision can be prevented. In the future,
this product will become a standard configuration as important as the high-position brake lamp when the
 automobiles come out of the factory.
The following are its specific features:
1: It is made of superior ABS plastic. Same color with the original car which enameled by baking (not
 painting), products surface has high glabrous degree. It is anti-aging; it also resists the corrosion, just
as the original car paint does.
2: Built-in lithium battery and high-efficiency micro generator. Lithium battry is automatically recharged
 by propeller. Generator is made of imported ball bearings. The service life exceeds 3 years.
3: The LED lights are specially customer-made. Its stability is superior; the brightness is close to the
 taillight; it has a good warning function to the drivers.
4: It has built-in high sensitive vibration sensor and sensitization system. It will automatically glimmer in
dark light, such as entering a tunnel, driving at dusk or in the evening. 120 seconds after the stop or
non-vibration of automobile later, the light will stop automatically. The LED will not flash when you
are driving in strong light or in the daytime.
5: It is very easy to be installed. Tear the tape at the bottom, then paste it on the top of the car.
Installaiton methods:
1. careflly using neutral detergent to wash off the dust and dirt before the installation.
2. Pull apart the double-side adhesive, draw the insulating pastern, and paste the product on the top of
 the vehicles.
Notes:
1.the double-sided adhesive only can be pasted once, can not be reused.
2.The long time low-speed driving can cause wind-charging insufficient, dim or even extinguish the light.
At this time can plug one end of the spare car-changer in the mini interface position of the bottom left
corner of the product; and the other end in the fire lighter to charge. The power supply cable can be held
out to the top of the automobile through the rear window. Charging time is about 15 to 20 minutes.
Remember do not exceed 30 minutes.