AMTSv1 Automated Mobile Test System Software (MT910 Series)

To perform TX/RX tests on mobile phones, the following equipment is needed in addition to the AMTS software: a phone to act as device under test (DUT), a tuner to vary the VSWR seen by the phone, a DC power supply to vary the voltage applied to the phone, and a Wireless Communication Test Set (i.e., Agilent 8960 or Rohde Schwarz CMU200) to act in signaling or non-signaling mode and test power and biterror rate (BER).

Mobile phones must guarantee proper functioning in non-ideal real-world environments, such as a lost or damaged antenna, usage in a tunnel or locker, being held close to the body or in a pocket surrounded by coins, etc. Each of these scenarios can be regarded as non-ideal from an RF standpoint, meaning non-50 ohm. Maury's AMTS software makes it possible to accurately measure the output power and receiver sensitivity of a mobile phone under conditions that simulate a variety of non-50 ohm environments. AMTS automates the testing of mobile phones in TX and RX modes over a multitude of channels/frequencies, battery voltages and power levels. Users are able to vary the VSWR magnitude and phase seen by the antenna port of the phone and test its real-time TX/RX performance.

Load pull consists of varying (pulling) the load impedance seen by a device-under-test (in this case the cell phone) while measuring its performance. This method is especially important for measuring large-signal nonlinear devices where the operating point may change with power level or tuning. Maury AMTS software is designed to automate these load pull measurements.

Mobile Phone TX/RX Load Pull

AMTS is designed to run under Microsoft? Windows 2000 and Windows XP.


The Maury Automated Mobile Test System Software (AMTS v1.00) is a standalone application designed specifically to automate the testing of mobile phones in transmit and receive modes, for output power and sensitivity respectively, as a function of VSWR magnitude and phase.

PDF (Portable Document Format) files can be viewed with
Adobe? Acrobat Reader.
from Adobe.com
of Maury Product Data Sheets and
Application Notes.

Contact Our Sales Department

Please contact our or your local
for more information about
AMTS v1.00 software.

Maury Microwave is Your

For RF Device Characterization Solutions

Introduction

Whatever your Device Characterization application,
Maury has a solution
that is designed to provide you with
CONFIDENCE IN MEASUREMENT!

AMTSv1 Automated Mobile Test System Software (MT910 Series)
Now With Support for GSM and WCDMA

  • Country:United States
  • telephone:1-909-204-3345
AMTSv1 Automated Mobile Test System Software (MT910 Series)
Now With Support for GSM and WCDMA
*Your name:
*Your Email:
*To:Maury Microwave
*Subject:
*Message:
Enter between 20 to 3,000 characters. English only.     Characters Remaining: 0 / 3000
*Enter the secure code shown below Mfrbee security Image      Reload Image

We do inquire for you , please wait ...