Flush Door

. No. Test Prescribed in IS: 2202 (Part-1, 1999) Minimum Value For conformity Observed Value 1. Dimension and Squareness Test as per IS : 4020 (Part 2), 1998 Height and width measured within an accuracy of 1.0 mm Within specified limits 2. General Flatness Test as per IS : 4020 (Part 3), 1998 Squareness measured to an Within specified limits 3. Local Planeness Test as per IS : 4020 (Part 4), 1998 Planeness measured to an accuracy of 0.1 m Within specified limits 4. Impact Indentation Test as per IS : 4020 (Part 5), 1998 Indentation measured to an accuracy of 0.1mm Within specified limits 5. Flexure Test as per IS : 4020 (Part 6), 1998 The deflection measured to an accuracy of 0.1mm Within specified limits 6. Edge Loading Test as per IS : 4020 (Part 7), 1998 The deflection measured to an accuracy of 0.1mm Within specified limits 7. Shock Resistance Test as per IS : 4020 (Part 8), 1998 4 to 5 shocks minimum Within specified limits 8. Buckling Test as per IS : 4020 (Part 9) 1998 Deformation measured to an accuracy of 1mm, 5 min.after application of the load and 15 min. after unloading Within specified limits 9. Slamming Test as per IS: 4020 (Part 10) 1998 50 times on the nail at the rate of 4-5 drops /min. Found O.K. 10. Misuse Test as per IS : 4020 (Part 11) 1998 Should pass after applying 200 N force to the handle at right angles to the plane of the frame. Satisfactory 11. Varying Humidity Test as per IS : 4020 (Part 12) 1998 Deviation measured to an accuracy of 1.0 mm Within specified limits 12. End Immersion Test as per IS : 4020 (Part 13) 1998 No de-lamination No de lamination found 13. Knife Test as per IS: 4020 (Part 14) 1998 Minimum Pass Standard Excellent 14. Glue Adhesion Test as per IS: 4020 (Part 15) 1998 There shall be no de-lamination No de-lamination found 15. Screw Withdraw as per IS: 4020 (Part 16) 1998 Applied load should be 2.0 mm per min. for complete withdrawal of the screw within specified limit Within specified limits Features Batterns made exclusively from selected single species of hardwood timber Batterns machined and planed to the required thickness, preservative treated and season kiln dried Batterns individually treated with insect toxicants for long lasting protection Available in both commercial and decorative grades Commercial face veneer thickness: 1.0 mm Decorative face veneer thickness: 0.5mm Bonded with boiling-water proof synthetic Phenol Formaldehyde adhesive Adhesive specially tinged with toxicants and antidotes Internal and external lipping can be provided at extra cost Available in double leaf Rebate cutting for double leaf doors available at extra cost Special construction and opening for vision available at extra cost Also available in non-standard sizes and thickness Usage Door shutters in homes and offices Precautions Handle with care to avoid damage and scratches Stored in a dry, clean and covered place with a raised and level surface Install only after finishing all construction works Clean surface before polishing and painting