Industrial Flooring Compound

The surface should be covered with a polythene sheet after final levelling and made air tight by placing sand around the sheet for a minimum period of 7 days.

(I) Sprinkle FAIRTOP by hand on peripherial area of width 100-150mm. When surface darkens with absorption of water, it is levelled with flat trowel or power float using dixc attachment. In areas where saw cut joints are tobe located, an extra quantity of floor hardner can be applied. Ensure that edges are fully Compacted.
(II) Sprinkle second part of FAIRTOP immediately after levelling of first part. Second part should be sprinkled evenly on entire area including the peripherial area and when surface darkens, level it with flat Trowel.
(III) After 2hrs. of first levelling, again the surface is levelled to close any pores and remove any adulations on the surface.

The sprinkling rate of FAIRTOP is 5kg/m2, so accordingly one can estimate the total quantity of FAIRTOP. After calculating total quantity of FAIRTOP, divide the quantity in four parts.

After laying of base concrete, when a person puts thumb on the concrete, the concrete should not stick on thumb but the impression of thumb remains on concrete, at that time sprinkling of FAIRTOP powder should be done on base concrete.

FAIRTOP is ready to use material, so no mixing is required before using it.

MIXING AND APPLICATION

As FAIRTOP is applied over fresh concrete, no surface preparation is required.

SURFACE PREPARATION

Flat trowel for levelling

APPARATUS

FAIRTOP is ready to use single pack, hard wearing, abrasion resistant, smooth finish anti skid industrial flooring compound for medium to heavy duty traffic floors. It resists penetration of oil and water. FAIRTOP is ready to use material the application is also very simple.

FAIRTOP
HARD WEARING, ABRASION RESISTANT MONOLITHIC
INDUSTRIAL FLOORING COMPOUND