Take a look at the grain
The grain of the rotary-cut veneer used on some engineered floors has a plywoodlike appearance when compared to flat-cut flooring.
In the end, choosing engineered flooring wont save you money. While an entry-level product may be less expensive than solid wood, a high-quality product will cost as much if not more, and the cost
of installation -- assuming both are prefinished -- is about the same.
The visual beauty of engineered wood is skin deep -- its essentially a thin wood veneer over a plywood substrate. But its practical qualities make it a good choice in moist environs where solid
wood cant go, such as below grade (for finishing a basement), or directly over concrete (ideal for the slab construction thats so common in California, Florida, and the Southwest). Whats more, the
total thickness of an engineered floor is only 3/8 to 5/8 inch, so it can be installed over an existing floor -- say, during a kitchen renovation -- with a minimal increase in level.
Most engineered flooring is available in tongue-and-groove strips which must be stapled or glued to the subfloor. Others, such as the long-plank types, which come as panels, are designed for use in
floating installations below grade or over concrete. A floating installation is one where the boards are glued to each other, and not fastened to the substrate at all, which allows the flooring to
shift with moisture changes.
Variety of veneers Theres tremendous choice in species -- and prices -- among engineered floors, from common domestic oak (left) to South American lapacho (right).
Virtually all engineered flooring comes prefinished, often with the eased edges mentioned earlier. The quality of this finish (usually indicated by the length of the warranty) and the thickness of
the wear layer are important considerations. The veneer on engineered floors ranges from about 1/12 inch (which generally cannot be sanded and refinished) to 1/4 inch (which can accommodate about
three sandings). Standard solid strip flooring, in comparison, can take up to seven sandings, depending on the species and the expertise of the refinisher. Many engineered floors can be abraded and
recoated if the finish is not completely worn.
When buying engineered flooring, choose a product with at least three layers of cross-stacked substrate (that is, with the grain going in opposing directions to lend structural stability). Five
layers will be even stronger, even if the overall unit isnt any thicker.
Its the makeup of the top wear layer, though, that determines how good an engineered floor looks. Some are made from rotary-cut veneers, which are sawn just like layers of plywood, by spinning the
log and slicing a continuous sheet from its circumference (photo above). Not surprisingly, the result is a floor that looks like its made from plywood. Flat-cut veneer is a better choice because
its milled like a very thin version of normal flooring -- by slicing along the length of the log. It is, however, more expensive and harder to find.
Most engineered flooring is available in tongue-and-groove strips which must be stapled or glued to the subfloor. |
W2S is a flexible and beautiful wall display tool, which can be used for any sample width, and can also be equipped with a tailor-made sample box. On the basis of large-area display, small samples that are easy to pick and place can be added to make the product series Presents ...
Come From Foshan EXE.Display Equipment Co.,Ltd
This curtain coater machine is suitable for flat-panel paint surface coating, the thickness of the paint is extremely accurate to ensure the uniformity of the overall coating surface. This wood coating machine is available to the surface paint coating like a mirror for the ...
Come From Suzhou Kisinhom Machinery Co., Ltd.
FD01 Classic Sand Wood Look Floating Cork Flooring wood look is soft and antiskid up to level 6. This type of cork flooring that looks like wood floor provides passive protection for the elderly and children\'s accidental falls, which can greatly reduce harm. Now the price of ...