Power Plus Tile Dry Bond

00 92   21 6324715

Fax Number:

00 92 334 3336333

Cell Number:

REHAN ANWER

Contact Person:

Not Required

Expert worker

Not Required

Watering after installation

Not Required

Scratching the old tiles

Not Required

Scratch the surface

Not Required

Sand Mixing

Not Required

Tile wetness

8 hours.

Ready time after Installation

20 kg is more than enough for 10m²

Consumption

4 5 hours

Installation period after ready mix

20 30 min

Installation period after Spreading

3.6 mm

Thickness

5.0 - 6.0

Chemical interference (acid, alkali, etc)

211 kg/cm²

Pressure handle

40.4 kg/cm²

Stickiness HOW TO USE: Mix two volumes of POWER PLUS BOND with one volume of water the surface for the laying (concrete, mortar beds, bricks/block, masonry, marble masonry, marble ceramic tiles etc). No chipping is needed. Just spread POWER PLUS BOND mortar, place the tile (or marble, stone, brick, etc.) on the surface and grout in the normal way. Recommended for use on Concrete, Concrete Block, Gypsum Wallboard, Wonder board, Expended Styrene, Foam Insulation Board, Brick. CERAMIC TILES, MOSAICS, PAVERS, QUARRY TILES For installing all types of floor and wall tiles. EXTRA-STRENGTH TILE DRY BOND Floor and Wall Thin-Set

EXTRA-STRENGTH TILE DRY BOND
Floor and Wall Thin-Set
FOR INSTALLING ALL TYPES OF FLOOR AND WALL TILES.