at toilet water valve. Unscrew floor bolt nuts and remove toilet. Discard old
floor seal and mounting bolts. The old floor flange may be used if it is in good
condition and has fastener holes that are positioned correctly. Make sure center
of floor flange is at least 11 inches (279 mm) from back wall (Figure A).
NOTE: If old floor flange cannot be used and cannot be removed, please use
a SeaLand Universal Mounting Kit, available from your SeaLand dealer.
2. When installing new floor flange, make certain that the toilet mounting bolts align
properly with Traveler toilet mounting pattern.
3. Secure flange to floor using flat head screws through countersunk holes in flange.
Insert floor bolts into slotted holes in flange (Figure B).
4. If toilet is being installed in a shower stall, apply a 1/4" thick by 3/4" wide bead of
glazing compound around the circumference of the floor flange (Figure C).
5. Traveler toilet models 111, 510 and 511 will accept handicap or household decorative
seats. Remove existing seat and replace with new seat if desired.
6. Position floor seal by pressing the floor bolts up through holes in the seal.
7. Set toilet in place with bolts protruding up through mounting holes in base
(Figure D).
8. Install washers and hex nuts provided with toilet. Tighten nuts down equally with
standard 7/16" open end wrench. Remove excess glazing compound from around
base in shower stall installation.
9. Connect water supply line to water valve (1/2" MPT) inlet using appropriate fittings
or an extension (Figure E).
10. Turn on water supply and flush toilet to test for leaks.
11. Attach pedestal and pedal covers to toilet base (see instructions below).
Pedestal and pedal Cover Installati on
at toilet water valve. Unscrew floor bolt nuts and remove toilet. Discard old floor seal and mounting bolts. |
Centrex 1000 Electric Features: (Shown with Toilet model 510) ...
Come From 406-777-4321
Centrex 1000 Non-Electric Features: (Shown with Toilet model 510) ...
Come From 406-777-4321