GSM Terminal Use For Call Termination

Witura Corporation Sdn Bhd

William Chin

If your esteem company needs more information or have any enquiry for the above, please feel free to contact us. Thank you and best regards

• Easy Installation. Just place SIM chip and connect a phone & you're ready to go
• Provides single FXS line per modules  
• Set caller ID on and off
• Compatible gain setting with Quintum, Clarent, Cisco and Vocaltech (proven test)
• Low cost way to setup VoIP termination
• Support answer supervision mode with Reverse Batt / Reverse Polarity Signaling
• Supports GSM 850/900/1800/1900 mhz
• Signal Strength meter with LED
• Block unwanted prefixes
• Able to show error with Front LED
• Power supply and high antenna gain included
• Clear and Neat by using 1 antenna for 4 GSM module
• Auto detection GSM network for 900 / 1800 /1900mhz
• Units are not locked to any provider or network. They can be used worldwide

Features

1. Connect the RJ 11FXS line to a VOIP gateway such as Clarent, Cisco, Quintum or Vocaltech.
2. This allows you to send calls from the US to the VOIP gateway which is now connected to the local GSM network. This allows a much cheaper cost that previous methods
3. This product is not a VOIP gateway. It is a GSM Fixed Wireless Terminal that produces a Analog FXS phone line
4. Eliminate the cost of routing calls to and from wireless phone through the PSTN. With the Fixed Wireless Terminal, you can direct outgoing calls to wireless service and route inbound calls from wireless phones through the unit
5. Available in tri band 900 / 1800 / 1900 mhz

This product is a GSM to Analog Converter. Once you insert a GSM Chip, the device will produce a FXS line to allow a regular phone to be connected and used just like a local land line except your calls will go out the GSM network. This device can both receive and make calls.