Probe Connector

[Detail of SlideRail]
The ProbeConnector can slide along the SlideRail and stop at any position on the SlideRail. The ProbeConnector can be fixed on the SlideRail by pulling the fix lever.
The SlideRail has ribs so that the convex section of the bottom of the ProbeConnector can be fitted to the ribs. The ProbeConnector never rotates horizontally.
The front and rear of the SlideRail's long side has dovetail grooves so that the SlideRails can be linearly connected to each other and the ProbeConnector core can be linearly aligned in one line.
The whole lower section of the SlideRail side has dovetail grooves. The ProbeConnector cores can be fit at right angles by fitting the dovetail groove protrusion at the rail front to the dovetail grooves.
By fitting the SlideRails to each other, The ProbeConnector cores can orthogonally connect to each other on four sides. A board where several signal lines are in one line can be measured by fitting several the SlideRails together so that the SlideRails will be at right angles with the SlideRail.
With a center rail, the ProbeConnector cores can be connected even though there is no signal line in a linear position on facing boards.

This product is a relay connector that connects to a signal line which stretches to the end of a microstrip board or coplanar board in lieu of a welded connector.
The board to be tested is placed on the GND block which moves up and down and is then sandwiched between an electrical ground (hereafter abbreviate as 'GND') block and GND receiving.
The ProbeConnector core with spring connects to a signal line on the board to be tested. The board surface ground connects to the probe contact with the GND receiving and the board's rear side ground connects to the ProbeConnector with the GND block.
The ProbeConnector core is output as an SMA connector inside the ProbeConnector in the coaxial structure and can be connected to a coaxial cable.
Applicable board thickness : 2.0mm at a maximum
GND block pressing force : 3kgf
Diameter of the ProbeConnector core : ?0.5mm
Core contact length : 0.55mm
Usable frequency range : up to 18GHz
Even when the SlideRail is integrated with the ProbeConnector, the SlideRail width is the same as the ProbeConnector (12.7mm)
Probe Connector width is the same as the SMA connector
Can use the "signal line" of contiguous
If you wish orthogonal set the ProbeConnector on board, please refer to [the probeConnector dimensions when a board is installed]
[The ProbeConnector dimensions when a board is installed]
Backside (GND block) : 3 x 12.7mm
Frontside (GND receiving) : 0.5 x 12.7mm
A board with mounted parts cannot be connected to the area described above.
[Design rules of a signal line neighborhood of a measuring object board]
Route the signal line to 0.2mm back from the end of the board.
The signal line width shall be 0.55mm or less.
Otherwise, the signal line will short out with the GND receiving.
Keep the surface GND near the end from the signal center by 1.34mm.
Route the rear side GND end to 0.2mm back from the measuring object board.