3 POINT DC STARTER

(c) Over Load (OL) release switch ? This is connected in series with the armature circuit. In case of current beyond the rated current of this coil in the circuit, this automatically trips the electromagnet, which is holding the handle in ON position. Thereby tripping the starter from being over loaded

(b) No Volt Coil (NVC) ? This is normally connected to Field circuit in a DC motor. In case of a failure in current in this circuit, for any reason, namely accidental tripping, or unintentional break in field circuit, this coil will provide a signal to the electromechanically held arm (handle) to release, and the starter is switched to OFF position, thereby providing safety to the system.

(a) To provide series resistance in a DC circuit when this starter is in START position. I.e. In STARTposition full resistance is included, and is reduced to zero ohms when the handle is moved to ON position, in discrete steps. The starter is held in ON position by an electromagnet. At this ON position the DC circuit gets its full current from the DC Rectifier unit. In the case of a DC motor, this is
connected in series with the armature circuit, to limit the starting current and eventually this resistance is CUTOUT, from the circuit. There by enabling the motor to run at it?s full armature current. Therefore this starter acts as a first order protection circuit, in between a DC rectifier unit and the DC circuit.

3 POINT DC STARTER

3 point DC starter is a unit intended to limit the starting current in a DC circuit. This starter is a must for any DC motor applications. This starter has three functions.

  • Country:India
  • telephone:91-171-2641604
Engineering, Polytechnic and Vocational Training Equipment-> Electrical Engineering Laboratory
*Your name:
*Your Email:
*To:INTERNATIONAL BIOLOGICAL LABORATORIES
*Subject:
*Message:
Enter between 20 to 3,000 characters. English only.     Characters Remaining: 0 / 3000
*Enter the secure code shown below Mfrbee security Image      Reload Image

We do inquire for you , please wait ...

Power 25W DC to 3GHz RF Fixed Attenuators Coaxial Attenuators with Impedance 50Ohm

Model Number: UIYCA25AN3A5 Frequency Range: DC-3GHz Power:25W Attenuation Value:5dB Attenuation Tolerance: ±0.5dB VSWR: 1.2 Connector Type: N-M/N-F Impedance:50Ω ...

Come From UIY Inc.

Fixed Attenuators Power 30W DC to 3GHz RF Coaxial Attenuators with Impedance 50Ohm

Model Number: UIYCA30AN3A30 Frequency Range: DC-3GHz Power:30W Attenuation Value:30dB Attenuation Tolerance: ±0.8dB VSWR: 1.2 Connector Type: N-M/ N-F Impedance: 50Ω ...

Come From UIY Inc.

Dummy Load DC to 3 GHz Power 25W RF Coaxial Termination Impedance 50Ohm

Model Number: UIYCT25AN3 Frequency Range: DC-3GHz Power:25W VSWR:1.15 Connector Type: N Male ...

Come From UIY Inc.