Aluminum Paste Lead Free For Solar Cells

product proved defective.

whatsoever in connection with their intended use. QuanPhotons only obligation shall be to replace such quantity of the

own test to determine the suitability thereof for their particular use, before using it. User assumes all risk and liability

out of its use by others. This information is furnished upon the condition that the person receiving it shall make their

infringe any patent. QuanPhoton assumes no liability for any injury, loss, or damage, direct or consequential arising

implied regarding the accuracy of these data, the results obtained from the use hereof, or that any such use will not

we believe to be accurate, but the accuracy and completeness thereof is not guaranteed. No warranty is expressed or

DISCLAIMER: The product information and recommendations contained herein are based on data obtained by test

during use or heating of these compositions. The use of safety goggles, gloves and hand protection creams is recommended. Wash hands or skin thoroughly with soap and water after using these products. Do not eat or smoke in area where the products are used. Read the MSDS and product labels before using the products.

organic and inorganic ingredients. Avoid  prolonged contact with skin or inhalation of any vapors emitted

Safety and handling: This paste is intended for industrial use by trained personnel. These products contain

Shelf life: AL8866 has a shelf life of 6months for the unopened containers when stored under the recommended conditions.

Storage: The paste should be stored in a cool and dry place away from direct sunlight at room temperature (5-30)with tightly capped containers.

Thinning: The paste is supplied at the viscosity provided by the customer, therefore, thinning is not commended. Contact our sales representative for appropriate solvent details.

Typical firing profile:

Firing: Optimum firing conditions will need to be established by the customer depending on exact type of furnace used, wafer characteristics, processing, etc. For a typical infrared furnace, it should be pre-heated at 200-300 and the peak temperature should be 760-930.

Drying: The paste can be typically dried in an infrared or conventional dryer with set points of 200 for 10-15 min.

Printing: 200-280 mesh screen with a