5" Square Single Solar Cell

NOTE: During the soldering procedure, first coat a small section of the bus bar with solder (use solder 40-60 flux core which melts at a low temperature such as 262 degrees C), then coat the strip of conductive ribbon, and then join the two solder-coated surfaces. Do not attempt to remove all of the light-absorbing coating of the bus bar as this often leads to rough cell handling and breakage.

  • Country:Canada
  • telephone:001-613-4495849
5" [12.5 cm] 16% efficiency monocrystalline cells:
2.5 watt, 5.0 amperes, 0.50 volt
*Your name:
*Your Email:
*To:Green-First Technologies Inc.
*Subject:
*Message:
Enter between 20 to 3,000 characters. English only.     Characters Remaining: 0 / 3000
*Enter the secure code shown below Mfrbee security Image      Reload Image

We do inquire for you , please wait ...

2.6W/Cell 5×5 (125mmx125mm) Monocrystalline Solar Cell

A solar cell is an electronic device which directly converts sunlight into electricity. Light shining on the solar cell produces both a current and a voltage to generate electric power. Eco-Source solar cells offer high efficiencies and good reliability. Advanced PECVD film ...

Come From Xiamen Eco-Sources Technology Co. Ltd

Black 2.5mm single core XLPE high quality solar pv cable

Widely used in indoor and outdoor solar installations, electrical installation, indoor and outdoor, explosion-prone areas, factories, industrial and agricultural industries. Low smoke without halogen, good cold, ultraviolet, ozone - resistant and weather - resistant. Flame ...

Come From Shanghai Hongsheng Wire and Cable Co Ltd

5M-20W Single Arm Solar Street Lights

We would like to recommend 5M-20W single arm solar street lights for you reference as follow: (Attached pls check tech specs for each part details solar street lights design) 1PC 20W COB LED Lamp & LED Housing,with original Bridgelux 1PC 125W Poly Solar Panel. 1PC 150Ah/12V GEL ...

Come From aloncorp