BSM Power Capacitor

OPERATION INSTRUCTION
Installed on dry and well-ventilated site, avoiding rain, snow and corrosion gases.
Installed 20mm or up off land. When two or more capacitors operated together, the gap of each other should be no less than 50mm.
Capacitors should be connected properly with soft wire of which current endurance is 1.35 times rated current or more.
Avoiding vibration and collision while transported or installed.
Keeping a certain delay duration for re-switching on in order to make sure that the residual voltage between terminal is no more than 10% of rated voltage.
To ensure capacitors working ordinarily compensators must be equipped with:
Discharge facilities (resistor)
Short-circuit protector
Protector for over-voltage of power frequency
Transient over-voltage protector (lightning-arrester or nonlinear resistor)
Rush current limiter
Over-current protector

SPECIFICATION
Service conditions: Ambient temperature-25 --+50, humidity

Installed on dry and well-ventilated site, avoiding rain, snow and corrosion gases.
Installed 20mm or up off land. When two or