Dip Diode

Circuits with Zener Diodes
Zener diodes are key components in the circuits: Make a Simple Battery Status Monitor, LM741 Voltage Indicator, and High Capacity Alternative to 9V Battery.

Using a 5.6V zener diode, and knowing the bulb draws a current of around one-sixth of an Amp, we can calculate the power loss in the diode (with Ohm's Law) to be just under 1 Watt. Therefore a standard 1.3 Watt zener diode should be up to the job.

For example, if you have a 1 Watt 6 Volt lightbulb to power from a 12 Watt regulated power supply, a 6.2V zener diode could be placed in series with the bulb giving the bulb 5.8V, or you could overpower the bulb a little using a 5.6V zener diode and dropping 6.4V across the bulb. Heat would be generated in the zener diode so it is essential to calculate the power lost in it so a suitably rated diode could be chosen.

Uses of Zener Diodes
Since the voltage dropped across a Zener Diode is a known and fixed value, Zener diodes are typically used to regulate the voltage in electric circuits. Using a resistor to ensure that the current passing through the Zener diode is at least 5mA (0.005 Amps), the circuit designer knows that the voltage drop across the diode is exactly equal to the Zener voltage of the diode.
Zener Diodes in Series With Loads
If you have a regulated fixed voltage - say 12 Volts from a desktop PC power supply, and you want to power something requiring a lower voltage, it is possible to simply place a zener diode in series with the load device. You would choose a diode with a zener voltage equal to the supply voltage minus the voltage drop across the load.

The illustration above shows this phenomenon in a Current vs. Voltage graph. With a zener diode connected in the forward direction, it behaves exactly the same as a standard diode - i.e. a small voltage drop of 0.3 to 0.7V with current flowing through pretty much unrestricted. In the reverse direction however there is a very small leakage current between 0V and the Zener voltage - i.e. just a tiny amount of current is able to flow. Then, when the voltage reaches the breakdown voltage (Vz), suddenly current can flow freely through it.

A Zener Diode is a special kind of diode which permits current to flow in the forward direction as normal, but will also allow it to flow in the reverse direction when the voltage is above a certain value - the breakdown voltage known as the Zener voltage.
The Zener voltage of a standard diode is high, but if a reverse current above that value is allowed to pass through it, the diode is permanently damaged. Zener diodes are designed so that their zener voltage is much lower - for example just 2.4 Volts. When a reverse current above the Zener voltage passes through a Zener diode, there is a controlled breakdown which does not damage the diode. The voltage drop across the Zener diode is equal to the Zener voltage of that diode no matter how high the reverse bias voltage is above the Zener voltage.

IN4001-IN4007,ZENER DIODES