MMIC AM254038WM-BM/FM-R
Product Details
DESCRIPTION
AMCOMs AM254038WM-BM-R and AM254038WM-FM-R are part of the GaAs HiFET MMIC power amplifier
series. It is a 2-stage GaAs HIFET PHEMT MMIC power amplifier. It is fully matched to 50-ohm at both input and
output, covering 2.4 to 4.4 GHz. The MMIC has 18dB gain and 38dBm output power at 12V. The BM package RF
and DC leads are coplanar with the bottom level of the package, which serves as ground, to facilitate low-cost
SMT assembly to the PC board. Because of high DC power dissipation, we strongly recommend to mount this
device directly on a metal heat sink. The FM package is the BM package mounted on a copper flange carrier.
There are two screw holes on the flange to facilitate screwing on to a metal heat sink. Both MMICs are RoHS
compliant.
TYPICAL PERFORMANCE ON A TEST BOARD*
Performance at Vdd = +12V, Vgs=-0.92V**, Idq = 1300mA, Ta = 25
- Country:United States
- telephone:1-301-353-8400
|
AMCOMs AM254038WM-BM-R and AM254038WM-FM-R are part of the GaAs HiFET MMIC power amplifier series. |
Send inquiry / quota request to MMIC AM254038WM-BM/FM-R
Relate products of MMIC AM254038WM-BM/FM-R
Place of Origin:Massachusetts United States RFIC, MMIC, RF and Microwave Front End module, PA, LNA, mixer, Gain block, etc.used in WiFi FEM, WiMax, Zigbee.. ...
Come From ChanCe
INTRODUCTION This application note describes the use and handling of AMCOM's BM MMIC power amplifiers. The amplifiers are housed in a 10-pin low cost surface mountable, ceramic package. The MMIC can be handled by standard pick and place equipment. ELECTRICAL SCHEMATIC Figure 1 ...
Come From AMCOM Communications, Inc.
INTRODUCTION This application note describes the use and handling of AMCOM's BM FET MMIC power amplifiers. The amplifiers are housed in a 10-pin low cost surface mountable, ceramic package. The MMIC can be handled by standard pick and place equipment. ELECTRICAL SCHEMATIC ...
Come From AMCOM Communications, Inc.
