Integrated Circuits

Accessories along with this Trainer board

Built in 3.3v Regulator

Built in USB port (LPC2148 INBUILT USB) for mass storage,HID Iinterface etc. 

Built in 10 Pin Frc for wireless module ADC(6 Channal 10 bit adc,5v,gnd).This is built in wireless module facility. 

Built in 4 pin for 10 bit DAC Port (3.3v,gnd,vref,Analog out); 

Built in 6 pin Connector for External interrupt(Eint0,Eint1,Eint2,Eint3,vcc,gnd). 

Built in 10 pin Frc Connector for 8 chnnal 10 bit adc interface 

Built in 10 pin Frc Connector for Ssp Interface 

Built in  10 pin Frc connector for PWM Interface 

16 nos. of built in 4 pin connecters (+5v,gnd,SDA,SCL) for interfacing with 16 I2C DEVICES. 

Distance range for wireless module is 100 meter (indoor application),1 km for outdoor application on line of sight.

Built in External Wireless modules to communicate with TXD,RXD,RTS,STS,DTR,DSR Signals with  jumper option to select UART1 with wireless Module 

Built in  External USB port to communicate with  TXD,RXD,RTS,CTS,DST,DTR signals with jumper option to select UART1 with USB. 

Built in  9pin D type Connector for ISP programming 

DEVELOPMENT BOARD BUILT IN FACILITIES

On-chip integrated oscillator operates with an external crystal in range from 1 MHz to 30 MHz and with an external oscillator up to 50 MHz. 

60 MHz maximum CPU clock available from programmable on-chip PLL with settling time of 100us . 

Up to 45 of 5 V tolerant fast general purpose I/O pins .  

Vectored interrupt controller with configurable priorities and vector addresses. 

Multiple serial interfaces including two UARTs (16C550), two Fast I2C-bus (400 kbit/s),SPI and SSP with buffering and variable data length capabilities.   

Two 32-bit timers/external event counters (with four capture and four compare channels each), PWM unit (six outputs) and watchdog.   

Single 10-bit D/A converter provides variable analog output.  

Two 10-bit A/D converters provide a total of 14 analog inputs, with conversion times as low as 2.44