Rotary Encoder E6b2

16)   When installing or removing the coupling, do not apply an excessive being. compressing , or tensile force

15)   When inserting the shaft in the coupling, do not use excessive force (by striking it with hammer, for example).

coupling ) the shaft will be subjected to an excessive load which will damage it or shorten its service life.Be careful when installing.

14)   If an installation error such as misalignment is too large,in case using the coupling or without 

Especially when linking with a chain , timing belt, or gears, connect a separate bearing before the coupling to the product.

13)   Be careful not to apply excessive load to the shaft .Excessive load may cause the product break.

12)   If the product is mounted and wired with a cord, do not pull the cord with force greater than29.4N.

11)   Be sure to turn off the power supply before wiring. If the output line contacts the power supply line while the power is being supplied, the output circuit may be damaged.

10)   Be careful not to expose the product to water or oil.

9)      Since the product consists of high-precision components, handle it with utmost care.

8)      Never disassemble ,repair nor tamper with the product

7)      Do not use the encorder under the environment with explosive or ignition gas.

6)      Do not short-circuit the load. Doing so may break or burn the product.

5)      Be careful when wiring, such as being careful with the polarities of the power supply .Incorrect wiring may break or burn the product.

4)      Since improper pulses may occur when the power is turned on or off, use the devices connected to this product at least O.1 seconds before or after the power is turned on or off.

Mininize the wiring length to prevent the product from being affected by noise, etc.

3  If surge occurs in the power supply, connect a surge absorber between the power supply terminals to absorb the surge.

2  Avoid wiring the products cables parallel to power lines or high-voltage lines. Doing so may cause the product to malfunction due to induction or may cause the damage the product.

1  Do not use the product in excess of the reated voltange .Applying voltages beyongd the rated voltage range may cause the product to break or burn.

Do not use the product in excess of the reated voltange. Applying voltages beyongd the rated voltage range may cause