DYNAMIC ROTARY TORQUE SENSOR CD 1050

The sensing element of FGP s torque sensors consists of thin-layer strain gauges associated in a Wheatstone bridge type configuration. FGP proposes a full range of conditioning and processing electronics for the torque sensors. Each electronic unit supplies the torque sensor, processes the measured signal and indicates the torque on a display meter. CD1050 PDF |?0 Technical specifications Ranges (ft/lb) A B C D E F G H I 10 to 100 40 50 12,7 (1/2") 32 20 42 80 50 4 X M3 110 to 300 50 55 19 (3/4") 40 25 45 105 60 4 X M3 310 to 800 60 60 25,4 (1") 50 30 50 120 70 4 X M4 810 to 3000 80 75 38,1 (1"1/2) 70 40 65 160 90 4 X M4 3010 to 7000 105 80 50,8 (2") 95 52.5 70 190 115 4 X M4 Temperature rangeOperating temperature range -20 to +80 Compensated temperature range (CTR) 0 to +60 Zero shift in CTR 0.01 % F. S. / Sensitivity shift in CTR 0.02 % F. S. / Measurement rangeFrom 0-10 Nm to 0-7000 Nm (other ranges on request). Overrange without damage 1.5 x F. S. Ultimate overrange 3 x F. S. RotationUp to 4000 rpm (depending on measurement range) Clockwise or counterclockwise directions Mechanical characteristicsSquare male coupling 1/2" ; 3/4" ; 1" ; 1"? ou 2" depending on range Other connections on request (smooth shaft, cotter pin, etc.) Accuracy0.25 % F. S. (linearity, hysteresis and repeatability) Electrical characteristicsSupply voltage 10 VDC nominal Sensitivity 1.5 to 2 mV/V Input / output impedance 350 or 700 & Electrical output 4 pin miniature Jaeger connector, mating supplied