Fire-Resistance Hydraulic Fluid

Availability: 208L drums

Withstands spike pressure: 5000 psi

Withstands continuous pressure: 3000 psi

Typical Operating Pressure: 2000 psi

Die CAST MACHINE

D.

Total Wear: 65 mg

Pressure Steel Pin & Vee Block

Test Conditions: Direct Load 2000 lb.

MODIFIED ASTM D-2670 FALEX-PIN & VEE BLOCK WEAR TEST

C.

40kg at 0.60mm

20kg at 0.50mm

7.5kg at 0.40mm

Test Conditions: 1200 RPM, 1 HR, RT. Load vs. Scar Diameter, mm:

MODIFIED ASTM D-4172 FOUR BALL WEAR TEST

B. 

Total wear on ring and vanes: 25 mg

Vanes: 7 mg

Results: CAM Ring: 18 mg

Test Period, hrs: 100 Test

Pump Speed: 1200 RPM (8 gpm)

Pressure, psi: 2000 Sump Temperature, F: 150

Test Conditions:

ASTM D-2882 VICKERS PUMP TEST

A.

Lubricity and wear characteristics:

Max Reserve Alkalinity: 210

Flash Point (F) : None, product contains water Fire Point (F) : None, product contains water ISO Particulate: 16 / 12

Percent water: 40%

Freezing point: -55F

Specific Gravity: 1.09 Pounds per gallon: 9.03

PH: 9. 6

Appearance: Clear red liquid Viscosity (SUS @ 100oF) : 200 SUS

Product Specifications:

Care and Maintenance: To keep operating at maximum performance levels, periodic monitoring should be conducted. Percent water level and alkalinity should routinely check to eliminate problems with fire resistance, viscosity variations or rust. Water content can be determined with the use of a refractometer or the Karl Fisher titration procedure. Alkalinity testing should be determined by titration.

Fluid Compatibilities: Compatible with most kinds of pumps including vane, piston and gear type units, safe to use with most packing and seals except polyurethane and silicone. Cork shaft seals should be replaced with Buna N or other synthetic rubber. Leather packing should be avoided; zinc or cadmium plated components should not be used this product.

Designed for use in high pressure applications where fire resistance, performance to local waste treatment regulations and good pump life are required, especially well suited for die casters, foundries, steel mills and mines.

Applications:

(iv) Conformance of ASTM D-2882 which enables fluid to be used in demanding operations without fear of excessive pump wear.

(iii) Factory mutual approval which enables fluid to be used in critical operations.

(ii) Excellent rust and corrosion protection which eliminates down time and wear on the system.

(i) Exceptionally low Phenol response levels (<60PPB) for ease of disposal.

Benefits:

Water glycol fire resistant hydraulic fluid formulated specifically for end users who require a phenol response level of less than 100 parts per billion (PPB) . By specially selecting raw materials to achieve a phenol response level of 60 PPB maximum while maintaining excellent lubricity, shear stability, rust protection and corrosion resistance. Conforms to ASTM D-2882 and is factory mutual approved.

Water glycol fire resistant hydraulic fluid formulated specifically for end users who require a low phenol content